Start-Up; Operation; Operating Mode; Operating Mode A - IKA KMO 3 basic Manual Del Usuario

Start-up

/// Operation

Check whether the voltage given on the ratings plate corresponds to the
available mains voltage If these conditions have been met, the device is
ready for operation when the power supply is plugged in If these conditions
are not met, safe operation is not guaranteed and the device could be
damaged Observe the ambient conditions (temperature, humidity, etc)
listed under "Technical data"
General power supply information
When the power supply adapter is connected to the device, the device changes
to the standby mode, the red LED "Standby" (B) is on and the display (C) will
not show any information
A display self-test will be performed following any interruption to the power
supply The display cycles through the following information:
All segments light up
1
Software version
2
The selected operating mode
3
If the drive has not been started the display reads "OFF"
4
If the drive has been started the selected speed is displayed
5
(only in operating mode b)
Power-up
Insert the power supply adapter into the power outlet (L)
1
The device is switched on and off via the "Power" button (A)
2
34 Start-up
Stirring
The stirring function is started and stopped by pressing
1
the "Start / Stop" button (G)
Increase or reduce the speed from 0 rpm to 1,500 rpm (in 10 rpm
2
steps) by pressing the "+ / -" buttons (H) Press and hold the "+ / -"
button (H) may quicken the adjustment of the speed
› The display (C) will only show the set value. If the actual speed is
lower than the set speed, the set value on the display will be flashing.
The set value on the display will stop flashing once the actual speed
reaches the set speed.

/// Operating mode

To toggle between operating modes, press the "Reverse rotation"
button (I) for 2 seconds when the device is powered on
› Factory setting: mode A

Operating mode A

All settings will be stored if the device is disconnected from the power
supply The agitation and "Set-up plate illuminated" functions will be
set to "OFF" when the device is powered on The "Start / Stop" button
(G) starts the device with the set parameters
Operating mode b
All settings will be stored if the device is disconnected from the power
supply The agitation and "Set-up plate illuminated" functions will be
set to "ON" or "OFF" when the device is powered on, depending on
the previous status of the device
Start-up 35