Before The First Use; Cleaning And Maintenance - Redmond RV-C316-E Manual Del Usuario

Where:
50 is the standard number of cleaning tasks per year
87 is the standard dwelling surface to be cleaned in m²
4 is the standard number of times that a vacuum cleaner passes over each point on
the floor (two double strokes)
0.001 is the conversion factor from Wh to kWh
1 is the standard dust pick-up
0.20 is the standard difference between dust pick-up after five and after two double
strokes
The annual energy consumption for hard floor vacuum cleaners .............................. 28.4 kWh/yr
AEhf=4*87*50*0.001*ASEhf*(1-0.2)/(dpuhf-0.2)
The annual energy consumption for general-purpose vacuum cleaners ................. 36.5 kWh/yr
AEgp=0.5*AEc+0.5*AEhf
Manufacturer reserves the right to make any modifications to design, packaging, or techni-
cal specifications of the product without prior notice.
Vacuum cleaner parts A1
1. Housing
2. Dust collection container
3. Hose connection hole
4. Carrying handle
5. Dust collection container release button
6. Rubberized wheels
7. "ON/OFF" button
8. Suction power control
Types of nozzles
A. «Floor/carpet» nozzle
B. Crevice nozzle for hard-to-reach places
C. Combination nozzle «2-in-1» (with brush to clean household appliances and polished
surface, without brush — to clean soft furniture).
I. BEFORE THE FIRST USE
Carefully remove the unit and its accessories from the packaging. Dispose of all packaging
materials and promotional stickers.
Keep all warning labels, warning stickers (if any), and serial number identification label
located on the housing.
After transportation or storage at low temperatures allow the appliance to stay at room
temperature for at least 2 hours before using.
Wipe the housing, the nozzles, the hose and the telescopic tube with a moist cloth and let them dry.
Vacuum cleaner can be plugged in only when it's fully assembled with correctly adjusted
filters and the dust collection container!
9. Output EPA-filter lid
10. Automatic power cord reeling button
11. Hose
12. Multipurpose «floor/carpet» nozzle
13. Crevice nozzle
14. «2-in-1» nozzle
15. Telescope tube
16. Nozzle storage fitting
II. OPERATION
Assemblage
1. Ensure the vacuum cleaner is unplugged before assemblage.
2. Put the dust collection container down onto projecting front part of the housing and press
down until it clicks.
3. Insert the special flexible hose fitting into the suction hole until it clicks into place.
4. Connect the hose handle to the telescopic tube and adjust the necessary nozzle.
Use
1. Press the lock on telescopic tube and adjust its length.
2. Pull the power cord by the socket to the desired length and plug in the appliance.
DO NOT stretch power cord beyond the red mark on the cable.
3. Press "ON/OFF" button on the housing.
4. Adjust suction power using the mechanical lock on the housing if necessary.
Maximum suction power is intended for hard floor coatings and heavily polluted carpets.
Minimum — for fine fabrics (e.g. lace curtains).
III. CLEANING AND MAINTENANCE
Unplug the vacuum cleaner before cleaning.
Dust collection container cleaning
Dust collection container should be emptied (even in case of underfill) immediately at the end
of operation.
1. Press the button to remove the dust collection container and pull. Fit the container under
trash can (bag), press the lid release button. Clean the dust collection container.
2. Close the dust collection container and fit it to the place.
Dust collection container and motor filter washing
It is recommended to clean filters and wash the dust collection container every two
months.
Remove the dust collection container and motor filter. Wash the motor filter and its components
under running water. Before fitting the sponge bag filter and motor filter let them dry com-
pletely.
Forced filter drying may lead to its deformation.
EPA-filter replacement
ЕРА-filter is fitted on the back side of the housing and fixed by the protective screen. The average
filter service life is 12 months, and then it must be replaced.
Ensure all the filters are correctly adjusted before reusing the vacuum cleaner.
Store the assembled appliance in a dry, ventilated place away from heating appliances and direct
sunlight.
RV-C316-E GBR
7