Onkyo SBT-A500 Manual De Instrucciones página 46

> Before Start > Part Names
3. Audio Adjust
■ 1. Multiplex/Mono
Multiplex Input Set the audio channel or language to be output when playing
Channel multiplex audio or multilingual TV broadcasts etc.
"Main (Default Value)": Main channel only
"Sub": Sub channel only
"Main / Sub": Main and sub channels will be output at the same
time.
0 If multiplex audio is being played, "1+1" will be displayed on
the display of the main unit when
is pressed.
Mono Input Channel Set the input channel to use for playing any 2 ch digital source
such as Dolby Digital, or 2 ch analog/PCM source in the Mono
listening mode.
"Left": Left channel only
"Right": Right channel only
"Left + Right (Default Value)": Left and right channels
■ 2. Dolby
Loudness When playing Dolby TrueHD, enable the dialog normalization
Management function which keeps the volume of dialog at a certain level. Note
that when this setting is Off, the Late Night function that allows
you to enjoy surround at low volumes is fixed to Off when playing
Dolby Digital Plus/Dolby TrueHD.
"On (Default Value)": Use this function
"Off": Do not use this function
46
> Install > Initial Setup
on the remote controller
> Playback
Supplementary information |
■ 3. DTS
DTS Auto Surround When inputting DTS signals that include extended channel
information, the optimum listening mode is automatically
selected according to the extended information contained in the
input signal and the speaker configuration of this unit when
playing in the straight decoding listening mode.
"On (Default Value)": Use this function
"Off": Audio is played using the same amount of channels in the
input signal according to the speaker configuration of this unit.
■ 4. LFE Level
Set the low-frequency effect (LFE) level for Dolby Digital series, DTS series, Multichannel
PCM, and DSD signals.
LFE Level Select the low-frequency effect (LFE) level of each type of signal
from "0 dB (Default Value)" to "j ∞ dB". If the low-frequency
effect sound is too strong, select "j20dB" or "j ∞ dB".
■ 5. Volume
Maximum Volume Set the maximum value to avoid too high volume. Select "Off
(Default Value)" or a value between "30" and "49".
Headphone Level Adjust the output level of the headphones. Select a value
between "j12 dB" and "i12 dB". (Default Value is "0 dB")
Advanced Setup | Others
E
N