Establishing Communications; Setting Up The Sender - Onkyo UP-TR1 Manual De Instrucciones

If you are using Rocket-
boost™ to wirelessly send
the audio signal to a sub-
woofer, then connect a
subwoofer cable from the
receiver subwoofer pre-
out jack to the UP-TR1
SUBWOOFER IN jack. If
you are not using Rocket-
boost™ with a subwoofer
then this connection
should not be made.

Establishing communications

Note: Every Rocketboost™ network must contain a device called a Hub,
which directs network data traffic and helps devices pair the network.
The network can have only one hub, which is selected using the Hub
Status switch on the back of all Rocketboost™ senders. If you are setting
up your network for the first time choose one of your Rocketboost™
senders to be your hub by setting the Hub Status switch to Enable. If
you already have a Rocketboost™ network, then set the Hub Status
switch on the UP-TR1 to disable. The Status LED lights green for the
Rocketboost™ Hub device, and lights blue for all other Rocketboost™
devices.
To establish communications:
1. Press the ON/STANDBY button on the UP-TR1 to turn it on.
2. Set the HUB STATUS switch to ENABLE if the UP-TR1 is to be
used as the network hub, otherwise set to DISABLE.
6
En-
Cable not
IN
provided
SUBWOOFER
UP-TR1
• The ON/STANDBY indicator lights green when the HUB STATUS
switch is set to ENABLE.
• The ON/STANDBY indicator lights blue when the HUB STATUS
switch is set to DISABLE.
Note:
When the HUB STATUS is set to ENABLE, power remains on
when your receiver is off. When the HUB STATUS is set to DISABLE,
the power will be off when your receiver is off.
3. Press and hold the ON/STANDBY button on the UP-TR1 for
more than three seconds to put it into pairing mode (it will
remain in pairing mode for 30 seconds). The ON/STANDBY indi-
cator LED starts blinking rapidly.
4. Press the ON/STANDBY button on the sender/receiver device
(the one configured as the hub) for more than three seconds, so
the sender and receiver will enter pairing mode.
• When connected, the ON/STANDBY indicator on both pairing
device and the hub will go solid, indicating the device is now
connected to the network.
• The ON/STANDBY indicator lights steadily if the link is activated
between both of the units.
• The ON/STANDBY indicator blinks at a slower rate if the commu-
nication link is not successful.

Setting up the Sender

Note: This is only required if you are using Rocketboost™ for your
Zone2, Surround, or Subwoofer audio.
To set up the Sender:
1. Press the ON/STANDBY button on the UP-TR1 to turn it on.
2. Press the PORT input selector on the receiver's remote control.
3. Press SETUP on the remote control to enter the Source Setup
menu for the UP-TR1.
4. Press  or  to select Sender Setup, then press ENTER.