Listening To Music From Other Rocketboost™ Products; Wireless Problems; Going Into Standby Mode - Onkyo UP-TR1 Manual De Instrucciones

5. Press  or  to select the Sender you want (TX1(*****),
TX2(*****), TX3(*****)), then press ENTER.
6. Press  or  to turn the selected Sender ON or OFF, then press
ENTER.
Note:
Set the Sender signals to OFF for any signals (Zone2, Sur-
round, or Subwoofer) that you are not using.
Listening to music from other Rocketboost™ products
To listen to music:
1. Press the ON/STANDBY button on the UP-TR1 to turn it on.
2. Press the PORT input selector on the receiver's remote control.
3. Turn on your other Rocketboost™ sender device (sold sepa-
rately) and make sure the audio source connected to that
device is active.
• The Rx indicator should be lit if a source is active on the network.
If not, check to make sure there is an active source.
• If there are multiple sources, you may need to press the SOURCE
button on the UP-TR1 to find the source you wish to listen to.
Each press will toggle through the available sources.
• You can also select the Rocketboost™ source using the UP-TR1
Source Setup menu. To do this, press PORT, and then SETUP on
the remote control to enter the menu. Then press  or  to
select the Source you want to listen to and press the ENTER but-
ton to select it.

Going into standby mode

To go to standby mode:
• Press the ON/STANDBY button and the STANDBY indicator will
light, indicating the device is in sleep mode.

WIRELESS Problems

If you don't hear any sound or if the audio is not synchronized,
check the following. This may solve the problem.
• Set the receiver's Speaker Configuration "Wireless" setting to
"Yes".
• Enable hub mode on the UP-TR1.
No communication between the UP-TR1 and your receiver
• Make sure that Hub Status switch on the UP-TR1 is set correctly.
• Make sure that the ON/STANDBY indicator on UP-TR1 and other
devices light solid blue/green. If the ON/STANDBY indicator
blinks slowly, try to establish the link again. For more informa-
tion, see "Establishing communications".
Cannot connect a source device
• If your network is already full with transmitters when pairing is
attempted, the source LED will blink three times and then turn
off. Remove (power down) a transmitting device and try again.
• When you try to pair a device to a network that has too many
nodes, the device will stay in pairing mode until it times out (30
second timeout). Upon timeout the unit should be on and flash
the ON/STANDBY indicator in a slow blink indicating it is not con-
nected to the network.
Specifications
Note: Design and specifications are subject to change without notice.
Wireless
Signal to Noise ratio: 90 dB (LINE, IHF-A)
Dimension (WHD): 15096125.5 mm (5-7/8"3-3/4"4-15/16")
Weight: 0.3 kg (0.7 lbs.)
7
En-