Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
10
www.raider.bg
circumstances, so before beginning work, consult with the responsible structural engineer, architect
or construction supervisor)
•
Clamp the workpiece in case it does not remain stationary from its own weight
•
Do not clamp the tool in a vice
•
Use completely unrolled and safe extension cords with a capacity of 16 Amps (UK 13
Amps)
•
Wear protective glasses and gloves, hearing protection , a dust mask, and sturdy shoes;
when necessary, also wear an apron
•
Always mount auxiliary handle 2 and protective guard 3; never use the tool without them
•
Be sure tool is switched off when plugging in
DURING USE
•
Inrush currents cause short-time voltage drops; under unfavourable power supply
conditions, other equipment may be affected (if the system impedance of the power supply is lower
than 0,25 Ohm, disturbances are unlikely to occur)
•
Always keep the cord away from moving parts of the tool; direct the cord to the rear, away
from the tool
•
If the cord is damaged or cut through while working, do not touch the cord, but immediately
disconnect the plug; never use the tool with a damaged cord
•
Keep hands away from rotating accessories
•
When grinding metal, sparks are generated; keep other persons and combustible material
from work area
•
In case of electrical or mechanical malfunction, immediately switch off the tool and
disconnect the plug
•
In case the cutting disc is blocked, resulting in jerking forces on the tool, immediately
switch off the tool
•
In case of current interruption or when the plug is accidentally pulled out, unlock the on/
off switch immediately and put it in the OFF-position in order to prevent uncontrolled restarting
•
Do not apply so much pressure on the tool that it comes to a standstill
AFTER USE
•
Before you put down the tool, switch off the motor and ensure that all moving parts have
come to a complete standstill
•
After switching off the tool, never stop the rotation of the accessory by a lateral force
applied against it.
•
WHEN CONNECTING NEW 3-PIN PLUG (U.K. ONLY):
•
Do not connect the blue (= neutral) or brown (= live) wire in the cord of this tool to the earth
terminal of the plug
•
If for any reason the old plug is cut off the cord of this tool, it must be disposed of safely
and not left unattended
GUARANTEE / ENVIRONMENT
•
Always keep tool and cord clean (especially the ventilation slots)
Do not attempt to clean ventilation slots by inserting pointed objects through openings
Disconnect the plug before cleaning
•
This "Raider"
regulations; damage due to normal wear and tear, overload or improper handling will be excluded
from the guarantee
•
In case of a complaint, send the tool undismantled together with proof of purchase to your
dealer or the nearest "Raider" service station
SAFETY INSTRUCTIONS
When using electric tools, the following basic safety precautions should always be followed to
reduce the risk of fire, electric shock and personal injury.
Read all these instructions before attempting to operate this product. Save these instructions.
product is guaranteed in accordance with statutory/country-specific
Publicidad
Tabla de contenido
