Mounting Using Din Sleeve; Disassembly - Man 3008 VOX Manual

4.3. Mounting using DIN Sleeve

Before installing, confi rm that this radio fi ts in the desired
mounting area and you have all the necessary kits to complete
the installation
• Install DIN Sleeve into the opening in your dashboard, lip
facing out.
• Push out the top and bottom tabs to hold the sleeve fi rmly
in place.
• Before inserting this radio in the sleeve, wire the antenna
(12) and DC (13) cable
• Make sure all the connections are routed away from any
potentially pinching or slicing other metallic parts.
• Slowly slide the radio into the sleeve until it locks in place.
• The rubber ring will act as a seal against DIN Sleeve.

4.4. Disassembly

If you plan to remove the radio from DIN Sleeve, you should do it
using the provided two removal keys as explained below:
• Fully insert both removal keys straight into the slot spaces
of the rubber ring on the left and the right edges of the
radio front panel.
• You cannot remove the radio if only one key is used.
• Press in fully and the radio will unlock from the sleeve
making withdrawal from the sleeve possible.
35