Asus V6 Serie Manual De Instalación página 4

Selecting the voltage
The system's power supply unit has a 115 V�230 V volta�e
selector switch located beside the power connector. Use
this switch to select the appropriate system input volta�e
accordin� to the volta�e supply in your area.
If the volta�e supply in your area is 100-127 V�� set the switch
to 115 V.
If the volta�e supply in your area is 200-240 V�� set the switch
to 230 V.
NOTE: Refer to the system User Guide for the exact location of the volta�e selector.
Removing the side cover and front panel assembly
1. Remove the cover screws on the rear panel.
2. Pull the side cover toward the rear panel until its hooks disen�a�e from the chassis tab
holes. Set the side cover aside.
3. Locate the front panel assembly hooks�� then lift them until they disen�a�e from the
chassis.
4. Swin� the front panel assembly to the ri�ht�� until the hin�e-like tabs on the ri�ht side of
the assembly are exposed.
5. Remove the front panel assembly�� then set aside.
Installing a CPU
Installing an Intel CPU
1. Locate the CPU socket on the motherboard.
2. Press the load lever with your thumb (2A)��
then move it to the left (2B) until it is released
from the retention tab.
CAUTION! To prevent dama�e to the
socket pins�� do not remove the PnP cap
unless you are installin� a CPU.

V7-P5G43 QSG.indb 4
1
3
2
3
1
3
2
Chassis tab holes
Installation manual
4
4
4
4
Retention tab
2A
2B
Load lever
��1�0� 4:5�:46 PM