Asus V6 Serie Manual De Instalación página 8

Hard disk drive
1. Remove the 3.5-inch hard drive holder out
of the chassis.
NOTE: The
optional.
2. Insert the hard disk drive to the 3.5-inch
hard drive holder�� then carefully push the
drive until its screw holes ali�n with the
holes on the holder.
3. Secure the hard disk drive with two screws on both sides of the bay.
4. Replace the hard drive holder to the chassis and secure the screws.
5. �or SATA ���: Connect the SATA
si�nal and power plu�s to the
connectors at the back of the drive.
�or I�� ���: Connect the I�� si�nal and
power plu�s to the connectors at the back of
the drive.
Reinstalling the front panel assembly and side cover
To reinstall the front panel assembly and side cover:
1. Insert the front panel assembly hin�e-like tabs to the holes on the ri�ht side of the
chassis.
2. Swin� the front panel assembly to the left�� then insert the hooks to the chassis until the
front panel assembly fits in place.
3. Insert the six side cover hooks into the chassis tab holes .
4. Push the side cover to the direction of the front panel until it fits in place.
5. Secure the cover with two screws you removed earlier.

V7-P5G43 QSG.indb 8
3.5-inch hard drive holder is
5
4
5
Chassis tab holes
Installation manual
3
SATA
5
2
1
1
2
1
2
3
2
3
2
IDE
��1�0� 4:5�:57 PM