Waves BL-12501 Manual De Instrucciones página 3

FEATURES
1. Measuring cap
2. Lid
3. Jug
4. Stainless steel blade
5. Safety switch
6. Housing
7. Switch
Switch speed setting
1. P = Pulse
2. 0 = Off
3. 1 = Low
4. 2= High
HOW TO USE
1. Place the container jug on the motor housing then slightly twist it anti‐clockwise until it
is locked. The container must be placed as shown on the above picture.
2. Put the products into the jug after dicing them then add the liquid, making sure not to
go over the maximum level marked on the jug.
3. Put the lid on the jug, and put the lid stopper on the lid.
4. Pug in the appliance and set the control switch to "1" or "2"".
5. Turn the appliance off by setting the control switch to "0", wait until the appliance has
completely stopped before removing the jug.
This product is equipped with 2 safety locks, one in the base and one is on the jug cover. It
only works when both the jug and container lid have been placed correctly.
CLEANING
1. First Remove the mains plug from the wall socket, do not immerse the motor housing in
water, you can clean the motor housing with a humid cloth. Do not abrasive cleaning
materials.
2. Disassemble the other parts after each use and wash them in soapy water. Then rinse
with clean water and dry thoroughly. Do not wash these parts in a dishwasher.
3. Cleaning is easiest when done immediately after use, or empty the jug and fill it with
water, turn the switch several times into the "pulse" setting.
CAUTION
•
Never use boiling liquids.
•
Never run the blender empty or with solids only.
This appliance is designed for intermittent operation. After 3 minutes continuously
operation it is required to switch it off for 3 minutes to prevent overheating.
Always follow the KB‐time (Kurzzeitbetrieb) or (short time usage) according to this manual.