Overview; Safety Information; Technical Specifications; Initial Operation - Parkside 291645 Traducción Del Manual De Instrucciones Original

Overview

1 High pressure connection
on the gun side
2 Cap nut
3 Top extension pipe
4 Bottom extension pipe
5 Brush
6 Pull-out lip
7 Adapter
8 Cap nut adapter

Safety information

Also observe the safety instruction
for your pressure washer.
Pressure washers can be dan-
gerous if used incorrectly. Do
not direct the jet at people, ani-
mals, live electrical equipment or the
equipment itself.
• To prevent damage, please also note
the manufacturer's instructions for the
object being cleaned.
• Use only original accessories and do
not carry out any modifications.

Technical specifications

Pressure washer brush attachment:
Suitable for high pressure cleaners with the
following performance data:
Rated pressure (p). .....11 MPa / 1595 psi
Max. pressure (p max) 16 MPa / 2320 psi
Max. flow rate (Q max) .............. 450 l/h
Max. inlet
temperature (T max) .......... 60 °C / 140 °F
Adapter:
Suitable for high pressure cleaners with the
following performance data:
Rated pressure (p) ........11 MPa / 1595 psi
Max. pressure (p max) . 16 MPa / 2320 psi
Max. flow rate (Q max) ................ 450 l/h
Max. inlet
temperature (T max) ..........60 °C / 140 °F

Initial Operation

Assembly:
1. Screw the brush (5) onto the bottom
extension pipe (4).
2. Screw the bottom extension pipe (4)
onto the top extension pipe (3).
Connecting without adapter:
1. Plug in and twist (Bayonet locking devi-
ce) to connect the pressure scrubber to
the spray gun of your PARKSIDE pressu-
re washer via the high pressure connec-
tion on the gun side (1).
2. Screw the cap nut (2) against the spray
gun for a firm grip.
Connecting with adapter:
1. Attach the adapter (7) to the high-pre-
ssure connection (1) and turn it through
90° until it locks into place (bayonet
locking device).
2. Screw the cap nut (2) on to the upper
extension tube (3) against the adapter
(7).
3. Connect the spray gun of the high pre-
ssure cleaner (bayonet locking device)
and screw the cap nut (8) of the adap-
ter (7) against the spray gun.
On all surfaces, test the brush (5)
initially on a location that is not
visible, in order to ensure compati-
bility.
GB IE
9