Raider PRO RDP-HD05S Manual Del Usuario página 12

12 www.raider.bg
movable part until the tool bore is wide enough
to allow the desired tool to freely fit. After fitting
the tool, tighten the movable chuck until you fix
the work tool. Make sure the tool is tight tight by
pulling it slightly along the machine axis.
8. Dismantling a tool from the conventional
chuck (pre-set !!!).
Fix the chuck ring loosely loosening the front until
the hole of the chuck becomes wide enough to
allow the tool to freely detach.
9. Turn the machine on and off.
ON - Press the trigger switch (position 1)
DISCONNECT - Release the starter switch (item
1).
10. Additional handle.
WARNING! The machine is equipped with a pro-
tective system when clamping or clamping the
working tool during operation. However, it is NOT
IMPLIED TO USE THE INSTRUMENT WITH-
OUT FITTING ADDITIONAL HANDLEBAR!
The additional handle allows for safe and stable
operation. Adjusting your required position is
done gently, simply unscrew the handle, place it
in the desired position and tighten again.
11. Deep Meter.
With the depth gauge you can precisely adjust
the depth of the holes.
12. Operating modes.
WARNING !!! NEVER MODIFY THE MODE OF
WORK AT THE TIME OF MACHINE OPERA-
TION!
- "Drilling" mode Press the release button and
turn the mode switch (pos. 2) in position.
- Curse Mode
Press the release button and turn the mode
switch (pos. 2) to the position
(Figure 1)
- Drill mode
Press the release button and turn the mode
switch (pos. 2) in position.
- "Cutter setting" mode
Press the release button and turn the mode
switch (pos. 2) to the position.
13. Sharpen sharpeners.
Well-sharpened chisels ensure quick and trou-
ble-free operation. It is desirable that the cutters
are periodically sharpened on a sander accord-
ing to the scheme shown in the figure:
(Figure 2)
(Figure 3)
(Figure 4)