Specifications; Operation - Denios 158052W Manual De Instrucciones

Adjusting the operating modes
On the tow handle of the lifting trolley there is a switch handle (H106) that can be switched in 3 positions (see Fig.
1): LOWER =lowering, NEUTRAL = transporting, ASCENT =
lifting.
If the lifting trolley does not react according to the chosen
switching position, this can be corrected by subsequent
adjusting of the adjustment screw (140H). After setting, all 3
switch positions are to be tested.

Specifications

Safe working load: 350 kg

Operation

Please observe the following instructions for working safely with the pallet truck.
•
The drums to be transported must be dry, oil- and grease-free.
•
Do not use on uneven ground
•
When operating the pallet truck we recommend wearing gloves and safety shoes.
•
If the drum lifting truck is not being used the forks must always be left lowered.
Drive the drum lifting truck in the lowered position very close to the drum to be transported. The ring-shaped forks of the truck
must surround the drum under the groove.
For lifting put the switch handle in the LIFT position and make up and down pumping movements with the tow handle. The
ring closes and the drum is held securely.
For transporting, the switch handle (H106) must be in the NEUTRAL position.
For unloading, put the switch handle in the LOWER position. When the drum touches the floor, release the
on the gripper F5807.
Faults
No. Fault
The forks do not reach
1
the maximum height.
The forks cannot be
2
raised.
The forks cannot be
3
lowered.
4 Leakages
The forks lower
5
unintentionally.
Fasshubwagen
158052
Cause
Too little hydraulic oil
Too little hydraulic oil
The oil is contaminated.
The relief valve is not set correctly
Air bubbles in the hydraulic oil.
5801
The shaft ( ) and the cylinder (3212) are
deformed because of inappropriate loading,
A component is damaged or deformed by
inappropriate loading.
The adjusting screw (140H) is incorrectly set
Seals worn or damaged.
Some components might be worn or damaged.
Impurities in the oil are blocking the relief valve (B)
Air bubbles in the hydraulic oil.
Seals worn or damaged.
Relief valve (B) is not set.
Seite 8 von 15 Seiten
locking device
Rectification of fault
Add more oil.
Add more oil.
Carry out oil change.
Set adjusting screw
remove air bubbles
5801) or cylinder
Change shaft (
(
3212)
Repair or change the component.
Set the adjusting screw (140H).
-Replace seals.
-Check and replace.
-Change oil.
-Remove air bubbles
-Change seals.
-Set the adjusting screw (140H).
Ausgabe 05/2010