Connection Diagrams - CFM E-bike Manual Del Usuario

5.4 Install pedals
Check 2 pedals, the one imprinted "L" should install in left side and "R" in right side.
Please use wrench to tighten them.
5.5. Install the seat post.
5.5.1 Open the seat post and saddle, then install the rear reflector;
5.5.2 Put the seat post into the frame;
5.5.3 Adjust seat post to the height that suits your riding position best and tighten quick
release. (Please make sure that the quick release is tightened firmly.)
5.6. Adjust angle
Adjust angle of brake lever, meter, gear shifter, throttle on handle bar, then tighten them
with tools.
5.7. Install battery
Each CFM e-bike comes with two copies of the battery key. Charging the battery on the
bike is likely to result in infrequent use of the battery key however, it is required for
maintenance and repair, so please keep this in mind when you store your key.
■Make sure you always have at least one spare key.
■Keep spare keys in a safe place for repairs, maintenance, and emergencies.
■Please bring the key with you when you contact your dealer for service or repair.
5.7.1 Open the box of battery
5.7.2 Tube the battery to correct angle and insert the battery into the holder gently, press
it down and lock automatically.
5.7.3. Integrated downtube battery outside the bike
• Insert the key to unlock the battery, and then pull the battery upwards.
• Remove the battery.
• Connect the charger to the battery.
• Connect the charger to a power outlet.
-11 -
• The charging process can be stopped at any time.
• Disconnect the charger first from the power outlet and then from the battery.
• Replace the battery and make sure it is correctly aligned at the bottom.
• Press the top of the battery until you hear a "click" to make sure the battery is properly
secured.
• Pull the key out.
• Your CFM e-bike is ready for use.
5.8. Change throttle (This is a giveaway, and only applies to european,
european customer can choose whether or not to change the throttle)
1. Take right side grip.
2. Connect two cables.
5.9. Connection
Diagrams
To increase the range, we
recommend switching to
speed. For starting and at
low speeds, a lower gear is best. At higher speed, a higher gear should be selected.
Reduce the pressure on the pedals during shifting for smooth support and improved range.
• High speed, high gear.
• Low speed, low gear.
• Reduce pressure on the pedals when shifting.
-12-