Levita T110-W Guia Del Usuario página 2

LEVITA T110-W - Digital Clinical Thermometer - User Guide
IMPORTANT NOTE
- It is important to clean your Thermometer before the first time of use and after
each application, otherwise the result may be incorrect.
- After a shower or exercise, the body temperature will rise. Take a rest before
taking temperature.
- If the ambient temperature is more than 35°C, dip the thermometer tip in cold
water for approximately 5 to 10 seconds prior to measuring the temperature.
- Stay with your child during measurement to assure proper use.
5.2 Oral use
Average measurement time 17 +/- 2 seconds
Average nomal temperature 37,0°C
IMPORTANT NOTE
- Drinking hot or cold fluids, exercising, smoking or performing other activities may
raise or lower your temperature. Therefore, it is important to relax for
approximately 5 minutes with your mouth closed prior to taking a reading.
- Place the probe under the tongue and close your mouth until the temperature
stabilizes.
- Keep the thermometer in one place without shifting it in the mouth.
• Place the probe tip under the tongue as near as possible to
the heat pocket. The diagram also shows the temperature
variables by not placing the tip in the heat pocket area.
• Close the mouth.
• Press the ON/OFF button (4) briefly. After all segments
have been displayed, 'L°C' flashes on the display.
• The thermometer starts measurement.
• When the temperature stabilizes at peak temperature, 4
beeps are audible and the result is displayed.
• Press the ON/OFF button (4) to turn the unit off or the unit will automatically shut
off after approximately ten minutes.
5.3 Axillary use (under arm)
Average measurement time 26 +/- 2 seconds
Average nomal temperature 36,5°C
• Wipe the underarm with a dry towel.
• Place the probe tip under the arm so the tip is touching the skin with the
thermometer perpendicular to the body.
• Position the arm across the chest so the probe tip is well covered by the arm. This
also insures the probe is not affected by the room's air.
• Press the ON/OFF button (4) briefly. After all segments have been displayed,
'L°C' flashes on the display.
• The thermometer starts measurement.
• When the temperature stabilizes at peak temperature, 4 beeps are audible and
the result is displayed.
• Press the ON/OFF button (4) to turn the unit off or the unit will automatically shut
off after approximately ten minutes.
2
V 1.0 - MD8100290