Publicidad
© 2009, Videolarm, Inc. All Rights Reserved
DEPUTY 2
Customizable Vandal-Resistant City Surveillance System
Installation and Operation Instructions for the following models:
D2BW1
Deputy2 Box with wall mount, support for up to 3 cameras.
110Vac input surge protection, H&B system and 24Vac output
to the camera. Space for user installed electronics
D2BB1
Deputy2 battery backup kit for a 12Vdc cameras
D2LK1B
Deputy2 ashing light kit, 1 long Blue LED ashing light with
mounting bar for Deputy2 Box
D2LK2B
Deputy2 ashing light kit, 2 long lasting Blue LED ashing lights
with mounting bar for Deputy2 Box
Before attempting to connect or operate this product,
please read these instructions completely.
www.videolarm.com
CERTIFIED
81-IN5436
07-13-2009
Publicidad
Tabla de contenido
Manuales relacionados para Moog Videolarm DEPUTY 2
Resumen de contenidos para Moog Videolarm DEPUTY 2
- Página 1 © 2009, Videolarm, Inc. All Rights Reserved DEPUTY 2 Customizable Vandal-Resistant City Surveillance System www.videolarm.com Installation and Operation Instructions for the following models: D2BW1 Deputy2 Box with wall mount, support for up to 3 cameras. 110Vac input surge protection, H&B system and 24Vac output to the camera.
- Página 2 IMPORTANT SAFEGUARDS SAFETY PRECAUTIONS Read these instructions. Keep these instructions. CAUTION Heed all warnings RISK OF ELECTRIC SHOCK DO NOT OPEN Follow all instructions. Do not use this apparatus near water. CAUTION: TO REDUCE THE RISK OF Clean only with damp cloth. ELECTRIC SHOCK, DO NOT REMOVE Do not block any of the ventilation openings.
- Página 3 LIMITED WARRANTY FOR VIDEOLARM INC. PRODUCTS VIDEOLARM INC. warrants this Product to be free from defects in material or workmanship,as follows: PRODUCTCATEGORY PARTS LABOR All Enclosures and Electronics Five (5) Years Five (5) Years Pan/Tilts Three (3) Years **6 months if used in autoscan Three (3) Years **6 months if used in autoscan /tour operation /tour operation...
- Página 4 Content of Box Electrical & Mechanical Specifications Deputy2 (X) 4 Power 120 VAC English Energía 120 VAC Español Puissance 120 VAC Français Energie 120 VAC Deutsch Poder 120 VAC Portuguese Alimentazione 120 VAC Italiano Note: Additional products may be included based around your purchase order...
- Página 5 Pole Mount Assembly Thread one retainer extrusion at the end of steel band, The Deputy2 can be mounted either on a pole or allowing 1” (254mm) of band out. Beveled end of surface extrusion to be out. • Un hilo de retención de extrusión en la final de la banda de acero, •...
- Página 6 Pole Mount Assembly Pole Mount Assembly Place assembly around pole at desired mounting location. Thread mounting hardware and additional retainer extrusion Insert bolt through retainer extrusions. Head of bolt needs to at opposite end of steel band. Refer to Block 1 and 2 for lock into end of retainer.
- Página 7 Pole Mount Assembly Installation is complete when nut is tight / secure and all slack has been removed from steel band. • La instalación es completa cuando es apretado la tuerca / garantizar la seguridad de todos y la atonía se ha eliminado de la banda de acero.
- Página 8 Wall Mount Assembly Wall Mount Assembly Attach with (4) anchor bolts, (4) lock washers, and (4) Place the mounting plate against the wall flat washers • Fijación con (4) los pernos de ancla, (4) arandelas de cerradura, y (4) arandelas planas •...
- Página 9 Wall Mount Assembly Hook the Deputy2 unit onto the top of the mounting Align the mounting holes plate • Enganche la unidad Deputy2 sobre la tapa de la pletina • Alinee los agujeros de montaje • Accrochez l'unité Deputy2 sur le dessus du plat de support •...
- Página 10 There are (2) water tight ” conduit fittings at the rear of the box. If only one is needed an IP66 hole plug is provided Completely tighten all four (4) bolts • Hay (2) agua firmemente guarniciones de 3/4 las” conducto en la parte posterior de la caja.
-
Página 11: The Deputy2 Can Be Customized With Several Cameras And Features
The Deputy2 can be customized with several cameras With an RM7 (see steps 26-31) and features • El Deputy2 se puede modificar para requisitos particulares con varias • Con un RM7 (26-31) cámaras y características • Le Deputy2 peut être adapté aux besoins du client avec plusieurs appareils-photo 26-31 •... - Página 12 Remove cover plate and gasket from the bottom of the RM7 installation unit • Quite la tapadera y la junta de la parte inferior de la unidad • Instalación RM7 • Enlevez le couvercle et la garniture du fond de l'unité •...
- Página 13 Attach the trim ring/dome assembly Remove the cover plate to install the camera mounts • Quite la tapadera para instalar los montajes de cámara • Ate el anillo del ajuste/el montaje de la bóveda • Enlevez le couvercle pour installer les montures de caméra •...
- Página 14 Electrical & Mechanical Specifications Antennas and light can be installed on the side of the Deputy2 Box. IP66 hole plugs are supplied for any • Open packet assembly. unused port (refer to blocks 43-48) • Special ⅜” bolts are provided and designed to mount either the WM20G or the WM10 (Standard Fusion Dome and •...
- Página 15 The (right) side electronics layout including optional The rear panel available for the customers electronic Battery backup installation equipment • La disposición lateral (correcta) de la electrónica incluyendo la instalación opcional del respaldo de batería • El panel trasero disponible para el equipo electrónico de los clientes •...
-
Página 16: Power Connection
120VAC INPUT: (120VAC) 120 VAC 220 VAC INPUT Transformer Wiring Brown 115V 50/60hz 110-120VAC INPUT Green Brn/Wht 24VAC at 3.5 a Black Green 115V 50/60hz Blk/Wht 120Vac Main Power Connection Input Switch Line (L) and Neutral (N) wires should be connected as marked on the board and plugged into the corresponding voltage for the input single phase. - Página 17 To install the optional light kit place the light-rack assembly on top of the Deputy 2 Box and bolt with (4) 1/4-20 screws with lock washer and flat washer • Para instalar el kit ligero opcional ponga el montaje del luz-estante encima del...
- Página 18 (2) Black Lead from Flashing Button Transformer for light kit, Mount the 24 VAC/24 VDC transformer to the side Black , White and Green Red Lead Black Lead panel with double sided tape Lead from Beacon from light from light transformer transformer •...
-
Página 19: Replacement Parts List
Replacement Parts List Deputy2... - Página 20 Replacement Parts List Deputy2...
- Página 21 Replacement Parts List Deputy2 Part Drawing # Description...
-
Página 22: Product Registration/Warranty
Product Registration/Warranty Thank you for choosing Videolarm. We value your patronage and are solely committed to providing you with only the highest quality products available with unmatched customer service levels that are second-to-none in the security industry. Should a problem arise, rest assure that Videolarm stands behind its products by offering some of the most impressive warranty plans available: 3 Years on all Housings, Poles, Power Supplies, and Accessories and 5 Years on all camera systems (SView, QView, Warriors), and InfraRed Illuminators.