Troubleshooting - Samsung 4 Serie Manual Del Usuario

Troubleshooting

If you have any questions of Tv, first refer to this list. If none of these troubleshooting tips apply, please visit 'www.samsung.com'
site, then click on Support or contact Call Centre on list of last page.
Issue
Picture Quality
Tv image does not look as good
as it did in the store.
Picture is distorted : macroblock,
small block, dots, pixelization
Wrong or missing colour with
Component connection.
Poor colour or brightness.
Dotted line on the edge of screen.
Picture is black and white with Av
(Composite) input only.
Picture freezes or is distorted
when changing channels or
picture is delayed.
Sound Quality
No sound or sound is too low at
maximum volume.
Picture is good but no sound.
Noise from speaker.
Solution
First of all, please perform the Picture Test to confirm that your Tv is properly displaying
test image.
● Go to MENU - Support - Self Diagnosis - Picture Test
If the test image is properly displayed, the poor picture may caused by the source or signal.
● If you have an analogue Cable/Set top box, upgrade to an Box. Use HDMI or
Component cables to deliver HD picture quality.
● Cable/Satellite subscriber : Try Hd(High definition) stations from channel line up.
● Antenna connection: Try Hd stations after performing Auto programme.
Many HD channels are upscaled from SD(Standard Definition) contents.
N
● Adjust Cable/Set top box video output resolution to 1080i or 720p.
● Confirm that you are watching the TV at the minimum distance recomended based on
the size and definition of the signal you are displaying.
● Compression of video contents may cause picture distortion especially on fast moving
pictures such as sports and action movies.
● low signal level or bad quality can cause picture distortion. This is not a TV issue.
● Mobile phones used close to the TV (cca up to 1m) may cause noise in picture on
analog and digital TV.
● Make sure the Component cables are connected to the correct jacks. Incorrect or loose
connections may cause colour problems or the screen will be blank.
● Adjust Picture options in the TV menu. (Picture mode, Colour, Brightness,
Sharpness)
● Adjust Energy Saving option in Setup menu.
● Try picture reset to view the default picture setting. (Go to
Reset)
● If picture size is set to Screen Fit, change to 16:9.
● Change cable/set top box resolution.
● Connect video cable(Yellow) to Green jack of component input 1 of the Tv.
● If connected with cable box, please try to reset cable box. (reconnect AC cord and wait
until cable box reboots. It may take up to 20 minutes.)
● Set output resolution of cable box to 1080i or 720p.
First of all, please perform the Sound Test to confirm that your Tv audio is properly
operating.
● Go to MENU - Support - Self Diagnosis - Sound Test
If the audio is OK, the sound problem may caused by the source or signal.
● Please check the volume of external device connected to your Tv then, adjust the Tv
volume accordingly.
● Set the Speaker Select option to TV speaker in the sound menu.
● Make sure audio cables from an external device are connected to correct audio input
jacks on the Tv.
● Check connected device's audio output option. (ex: You may need to change your
cable box' audio option to HDMI when you have HDMI connected to your TV.)
● If you are using a DVI to HDMI cable, a separate audio cable is required.
● Deactivate SrS function if you are setting the volume over 30 value.
● remove plug from headphone jack. (if available on your Tv)
● Check cable connections. Make sure a video cable is not connected to an audio input.
● For Antenna/Cable connection, check signal strength. low signal level may cause
sound distortion.
English - 30
MENU - Picture - Picture