Scanning
Loading Photos
Loading Documents
You can insert different types of document into
your device. Follow the specifications in the tech-
nical data.
You can scan documents using the protective
cover to avoid the photo or document being dam-
aged by scratches or creases.
Notice
Scanning documents with the protective
cover
If smaller documents are scanned using
the protective cover, in certain cases,
the automatic cutting off function does
not function properly. Either important
parts of the image are cut off or too
much edge remains around the docu-
ment. In this case, scan the documents
without using the protective cover.
Scanning documents with the protective cover
CAUTION!
Unsuitable Documents!
No paper clips, staples, fixing pins or
similar may be retained on the docu-
ments.
1 Open the protective cover and insert the docu-
ment with the printed side facing up.
2 Lay the protective cover into the document
feeder with the printed side facing upwards,
the closed side of the page (black lines) for-
ward and the page header in the direction of
the # button.
3 Align the protective cover to the left hand
edge.
4 Fix the protective cover in place using the doc-
ument guide on the right hand side. The docu-
ment guide should lightly touch the protective
cover.
5 Slide the protective cover horizontally as far
into the document feeder until it is automati-
cally fed into the scanner and the scanning
process is started. Ensure you do not bend the
document. The control lamp POWER flashes
during the scanning process.
DANGER!
Document Jam!
Do not insert documents into the
feeder whilst the device is scanning.
This can lead to a paper jam.
6 Wait until the control lamp POWER and the
control lamp STATUS are no longer flashing
and the control lamp STATUS is continually
on. This means that the scanning process is
completed and the data was saved onto the
memory card.
DANGER!
Document Jam!
Wait until both control lamps are no
longer flashing before you insert the
next document in order to prevent a
document jam.
EN
6