Makita 2704 Manual De Instrucciones página 9

1. Position the rip fence in the sliding position.
2. Loosen the two hex bolts on the rip fence with the
hex wrench provided.
3. Adjust the rip fence until it becomes parallel with
the blade.
4. Pivot down the knob on the rip fence toward the
operator.
5. Tighten the two hex bolts on the rip fence.
CAUTION:
• Be sure to adjust the rip fence so that it is parallel
with the blade, or a dangerous kickback condition
may occur.
When the rip fence cannot be secured solidly, adjust it
according to the following procedure.
(1) Set the rip fence on the table and then pivot
the knob on the half way of its travel (moving
position). Tighten the screw (A) until the rip
fence is immobilized. Then loosen a 1/4 to 1/2
turn.
2
1
1
3
4
(2) Tighten the screw (B) fully and then loosen
about 2 full revolutions.
(3) Lock the rip fence by fully pivoting the knob
on the fence holder (lock position).
006215
007778
1. Rip fence
2. Released posi-
3
tion
3. Moving position
4. Lock position
4
007779
1. Rip fence
2
2. Moving position
3. Screw (B)
4. Screw (A)
(4) Make sure that the rip fence can be installed
and removed in the original position (released
position).
(5) Make sure that the rip fence can be slid
smoothly with no wobble when the knob is on
half way of its travel.
CAUTION:
• Be careful not to tighten screws with more than
tightening amount specified in the above instruc-
tions. Failure to do so may damage the fastened
parts.
Bring the rip fence up flush against the side of the blade.
Make sure that the guideline on the fence holder points
to the 0 graduation. If the guideline does not point to the
0 graduation, loosen the screw on the scale plate and
adjust the scale plate.
1
OPERATION
CAUTION:
• Always use "work helpers" such as push sticks and
push blocks when there is a danger that your hands
or fingers will come close to the blade.
• Always hold the workpiece firmly with the table and
the rip fence or miter gauge. Do not bend or twist it
while feeding. If the workpiece is bent or twisted,
dangerous kickbacks may occur.
• NEVER withdraw the workpiece while the blade is
running. If you must withdraw the workpiece before
completing a cut, first switch the tool off while hold-
ing the workpiece firmly. Wait until the blade has
come to a complete stop before withdrawing the
workpiece. Failure to do so may cause dangerous
kickbacks.
• NEVER remove cut-off material while the blade is
running.
• NEVER place your hands or fingers in the path of
the saw blade. Be especially careful with bevel
cuts.
• Always secure the rip fence firmly, or dangerous
kickbacks may occur.
• Always use "work helpers" such as push sticks and
push blocks when cutting small or narrow work-
pieces, or when the dado head is hidden from view
while cutting.
9
006214
1. Guideline
2. Screws
2