GYS POWER HUB MODULE Manual Del Usuario página 10

Translation of the original instructions
PREPARATION
Before wiring the product, make sure that all chargers are switched off and that no batte-
ries are connected (risk of short circuit).
1 Unscrew the cover (5) of the PHM (6 screws).
Connection inlet PHM
Remove the clamps from the power cables of the GYSFLASH chargers.
2
If the charging cables are too long
- Cut the cables to the desired length.
- choose the appropriate lug
crimp with appropriate pliers.
-
- Shrink tubing to the wall
The length of the cable must not be less than 1 m.
Pass the red cable through an input cable gland + (1) of the housing.
3
And the black cable in an inlet cable gland - (2) of the housing.
Screw the cables to the corresponding plate with the screws provided in
4
the bag (red cable to Cu plate + above / black cable to Cu plate - below).
Tighten the screws well (5 Nm) .
5 Tighten the cable glands used.
10
POWER HUB MODULE
(2.5 or 5 m depending on the GYSFLASH)
(10, 16 or 25 mm² depending on the GYSFLASH cable(s))
(use 25 mm of the 200 mm tubing heat-shrinkable supplied).
2
:
.
EN
1