THOMSON ROC240 Manual De Instrucciones página 5

Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 18
ROC 240
16/05/01 17:07
It may be useful to retrieve the code programmed in the remote control.
1. Set the selector (13) on the type of set concerned (TV or VCR).
2. Hold down the key SHIFT (4) until the red indicator lamp (11) remains lit.
3. Press SHIFT (4) again briefly. The red indicator lamp flashes once.
4. Press the number keys (0 to 9) in ascending order until the red indicator lamp
(11) flashes once.
5. The digit which made the red indicator lamp (11) flash, is the first number of the
3-digit code. Please note it down below.
6. Repeat step 4 to find out the two other numbers of the code.
7. When the third number is found, the red indicator lamp (11) goes off.
- For a TV set: press for instance number key 2 to switch over to another channel or to switch the set on, in case
it is off.
- Video recorder: load a tape and then press B .
Try other remote control keys to find out the range of functions you can control. If you think that not all of the keys
are active, try the programming Method B or C.
When you have retrieved the code of your set, jot it down so that you can use it whenever
needed.
After battery replacement, you'll have to programme the remote control again.
The THOMSON NAVILIGHT system allows you easy access to the settings of your
television (TV) or video recorder (VCR) including this feature.
1. Switch on the set you want to control.
2. Set the selector (13) on the type of set concerned (TV or VCR). In the VCR
position, make sure that the AV mode is activated for the TV set (the SCART socket
must be selected).
3. Press the SHIFT key once and then menu (6).
4. To travel through the setting menus, press the SHIFT key once and then use the
keys up, down, left and right (16 and 17).
5. Validate with OK (7).
6. To leave the menus, press SHIFT once and then the exit key (15).
Page 4
4 – How to retrieve a programmed code
5 – Check of the programming
TV CODE
6 – The NAVILIGHT system
You can contact THOMSON by dialing:
from 27 November 2000.
(For Great-Britain, all calls will be charged at local rate)
www.thomson-europe.com
VCR CODE
0845 601 3093,
4
+
+
+

Publicidad

Tabla de contenido
loading

Tabla de contenido