Troubleshooting And Repair; Environmental Conditions - Whip Mix VeriWash Manual Del Usuario

VERIWASH User Manual

8. TROUBLESHOOTING AND REPAIR

VERIWASH has been designed to enable the user to replace parts or fix the unit without
sending it anywhere. Replacement parts are readily available at www.shop.whipmix.com.
If problems do occur, consult the chart below. If additional information is needed, watch the
appropriate videos on the Whip Mix channel at www.youtube.com.
If still not satisfied, refer to the warranty agreement to determine your course of action. If
the unit is out of warranty, contact Whip Mix at (800) 626-5651.
Error
Loud noise
Unusual noise
The Display doesn't turn off
The Display doesn't turn on
Motor Jammed

9. ENVIRONMENTAL CONDITIONS

Installation: Indoor use
Altitude: up to 2,000 m
Operating temperature/humidity: 5–40°C / 20–80 %
Pollution degree: 2
Degree of protection: 1
Cause
High concentration of resin
in alcohol (viscosity change)
affects rotation speed
Obstruction in the Wash
Container
Software issue
Software issue
Faulty electrical connection
Misaligned impeller or debris
stuck around it
10
Whip Mix Corporation
Solution
Adjust the speed – refer to the
operation process.
Check for loose parts or debris
on the bottom of the bucket.
Check that the impeller rotates
properly.
Disconnect and reconnect the
power (restart).
Disconnect and reconnect the
power after 1-2 min (restart).
Check the power supply. Try
another outlet.
Disconnect and reconnect the
power.
Check for loose printed parts
or debris stuck under the
impeller and remove it.
Check the impeller alignment
and proper rotation. Contact
Whip Mix for instruction.