Operation - Whip Mix VeriWash Manual Del Usuario

VERIWASH User Manual
4.5 Use the Universal Build Plate Jig and the Metal Rods to wash the printed
parts while they are attached to the build plate and the build plate size is up
to 180 mm x 90 mm (7.08" x 3.54").
4.5.1
4.5.2 Check the proper position of the build plate over the two Metal Rods,
4.5.3 Insert the Universal Jig with the positioned Metal Rods inside the
4.5.4 Secure the printer build plate over the positioned Metal Rods.
4.6 Insert either the Mesh basket or the Universal Jig into the Wash Container
as instructed in 4.4 or 4.5.
4.7 Insert the AC cable into the receptacle in the back of the unit.

5. OPERATION

5.1. To turn on the unit, select and press the MODE button depending on which
Wash Container you want to operate - left, right, or both. LED (Blue) light
indicates which container is selected.
5.2 Select the TIME (3 min, 5 min, or 10 min).
NOTE: Time cannot be changed while the cleaning cycle is in
progress.
5.3 Do not start the unit until the Containers, the Lid/Mesh Basket, and the
Universal Jig are all secured in their proper position.
Position the Metal Rods in the slots of the Universal Jig based on the
size of your printer build plate.
NOTE: Check and adjust the position of the two Metal
Rods several times until the build plate is placed over
them securely.
set aside.
Wash Container.
NOTE: Ensure printed parts are fully secured to the build
plate. Washing loose parts directly in the wash container
may damage printed parts, create noise, and interfere
with the impeller at the bottom.
Left Right Both
7
Whip Mix Corporation