Operation Book - Service And Maintenance; Troubleshooting - Hallins NEWTON 50 Manual Del Usuario

Every month
1. Check all electrical connections and components and rectify any damage and wear.
Replace with new parts where necessary.
2. Check the chassis, mast and load bed as regards all types of defects, cracks, misalign-
ment, corrosion etc., and that all locking devices are in place and correctly attached.
3. Check that all wheels rotate freely and that the tyre rubber is intact. Lubricate the ball
bearings in the race.
4. Check that the wheel brakes are undamaged and work properly.
5. Check that the drive chain is undamaged.
6. Check that all stickers are legible and are in their right places.
7. Check that any strapping devices that may be used for the goods are intact and in
working order
8. Lubricate the inside of the mast with oil spray
10 OPERATION BOOK • SERVICE AND MAINTENANCE
Product service book:
Part number:
Serial number:
Delivered:
Service interval:
Example of content that must be completed during each service.
SERVICE & MAINTENANCE
Date:
Signature:
Observations:

11 TROUBLESHOOTING

The lifting trolley has been designed and tested to achieve optimal operational reliabi-
lity and service life, under the proviso that routine maintenance is carried out in accor-
dance with the specified instructions.
In the event of malfunction, always remove the load from the platform/lifting device
before carrying out troubleshooting and repairs. Inspections, service and repairs must
be carried out by qualified repairmen.
Symptom Procedure
Load bed does not move on signal
A. Check that control unit and charger are not defective
B. Connect the power cable to the mains and let it remain on charge for at least 8 hours.
If problems persist after you have taken these measures, you should contact an authori-
sed repairman or your supplier.
21