Adapter Bracket Assembly (X2) - Tripp-Lite DDR1327SQFC Manual Del Propietário

4. Install Adapter Bracket Assembly
To tighten the adapter bracket assembly, push the plastic handle in and turn upward until it can turn no more.
Then pull the plastic handle out to disengage from the hex bolt and turn it down to the bottom position. Once
again, tighten by pushing the plastic handle in and turning upward until it can turn no more. Continue process
until firmly secured.
Note: Repeat the same process to loosen, except push the plastic handle downward from the top position.
14-06-218-933380.indb 6
collar
Insert the adapter bracket assembly
onto the pole and slide it down until it
touches the collar.
tighten
adjust handle
6
7/24/2014 3:13:55 PM