Publicidad
Idiomas disponibles
Idiomas disponibles
2
REAR WHEEL OPENING FLARE MOLDING
1.
Remove the torx head retainers (2) and screw (1) and
remove the rear wheel opening spat (3).
2.
Install the supplied j-clips to the wheel opening
as needed.
3.
Clean and prep the area where the flare molding
will be attached.
4.
Position the flare (1) to fender aligning attachment
holes with holes in fender flange.
5.
Install the push-pin (1) first for correct flare positioning.
Install the 8 screws (2) in sequence starting from the
center and proceeding outward. For a correct fit, hold the
flare tight against the fender as the screws are tightened.
Tighten to 2.3 N•m (20 In. lbs.).
6.
Remove the protective film from the back of the fender
flare and apply pressure.
11/04/2008
1
2
3
1
2
K6860855 REV. 1
1
Publicidad
