Elu After-Sales Service - Elu WS50 Manual De Instrucciones

E N G L I S H
Prior to operation:
• Install the appropriate guard and disk or wheel.
Do not use excessively worn disks or wheels.
• Be sure the spacer and threaded flange are
mounted correctly.
• Make sure the disk or wheel rotates in the direction
of the arrows on the accessory and the tool.
Switching ON and OFF (fig. A)
The ON/OFF-switch of your angle grinder is
equipped with an unlocking switch or a locking
switch for continuous operation.
(U.K. & France only) -
ON/OFF-switch with unlocking switch
• To unlock the ON/OFF-switch, slide the
unlocking switch (2) towards you.
• To run the tool, press the ON/OFF-switch (1).
• To stop the tool, release the ON/OFF-switch.
ON/OFF-switch with locking switch
• To run the tool, press the ON/OFF-switch (1).
The tool now runs in continuous operation.
• To stop the tool, press the locking switch (2a)
briefly, and release the ON/OFF-switch.
Do not switch the tool ON or OFF when
under load.
DT53EK - Using the diamond guard (fig. C)
The diamond guard is used for cutting concrete and
masonry, when accurate cutting depth adjustment
or dust extraction are required.
• Mount the diamond guard as described above.
• Connect a dust extractor to the outlet (17).
• Set the cutting depth using the ruler knob in the
front plate (13).
Observe the safety instructions applying
to diamond cutting disks.
Use a suitable diamond cutting disk
(check the data of the manufacturer).
The maximum rotation speed on the
cutting disk must not be lower than that
of the tool. Do not use cutting disks with
a diameter exceeding 230 mm.
24
WS51E.PM65
DT53EK - Using the round handle (fig. F)
The round handle provides greater convenience and
makes your tool very easy to handle.
• Mount the round handle as described above.
Consult your dealer for further information on the
appropriate accessories.
Maintenance
Your Elu Power Tool has been designed to operate
over a long period of time with a minimum of
maintenance. Continuous satisfactory operation
depends upon proper tool care and regular cleaning.
Lubrication
Your Power Tool requires no additional lubrication.
Cleaning
Keep the ventilation slots clear and regularly clean
the housing with a soft cloth.
Unwanted tools and the environment
Take your tool to an Elu authorized repair agent
where it will be disposed of in an environmentally
safe way.

Elu After-Sales service

All Elu Power Tools are thoroughly tested before
leaving the factory. However, if the Power Tool
needs repair, please contact your dealer or the Elu
Head Office for the address of the nearest Elu
authorized repair agent (please refer to the back of
this manual).
24
Fire hazard! Do not use the dust
extractor when cutting metal!
Make sure that the dust extractor used is
suitable for the material to be cut and the
Diamond guard can be connected.
17-09-2001, 10:26