Intex Sun Shade Pool Instrucciones De Montaje página 2

ENGLISH
Set up:
Depending on the size of the product, 2 or more adults are recommended for setup. Set up time may vary from 10
to 20 minutes excluding water fill time.
1. Find a flat, level lawn surface that is free and clear of stones, branches or other sharp objects that may puncture
the pool liner or cause injury. Certain types of grass such as St. Augustine and Bermuda, may grow through the liner.
Grass growing through the liner it is not a manufacture defect.
2. Move the product (in its package) to the selected site before inflating – do not inflate the product and drag it since it may
result in leaks or damage.
3. Slowly unfold the product and inspect the product for rips, tears or punctures. Do not use if the product is damaged.
4. Lay the pool out as evenly as possible and close all drain plugs and/or exhaust valve caps if any.
5. Inflate the bottom air chamber first with a manual air pump designed specifically for inflatable products, and then the next
chamber or chambers in sequence.
6. Fill the product with air until the surface is firm to the touch. If there is any straining at the seams, the product is over
-inflated. If any seam begins to strain, immediately stop the inflation and release air to reduce the pressure until signs of
stress on the seam are gone. Do not over-inflate or use high pressure air compressor since it may result in seam leaks.
7. Close and recess all inflation valve cap(s) securely by pushing down firmly on it.
8. Slowly fill with water to a safe level for intended users.
INSTRUCTIONS FOR PRODUCTS WITH WATER SPRAYER AND
OTHER ACCESSORIES (VARY FROM MODELS):
Attaching the water sprayer
1. Locate the sprayer connector (A).
2. Attached the sprayer connector (A) to a garden hose (B) by threading the sprayer coupling onto the garden hose. Tighten
securely.
3. Turn the water on slowly at first to allow water to gradually fill in. Then adjust the spray as desired.
4. If an adaptor is provided (vary with models), thread the adaptor (C) to the sprayer connector (A) and insert the garden
hose (B) into the adaptor (C).
POOL MAINTENANCE & DRAINAGE
• Inspect the pool at the beginning of each use for holes, leakage, wear and tear and other damages. Never use a
damaged paddling pool.
• Water can easily be contaminated. Change the water of paddling pool frequently (particularly in hot weather) or when
noticeably contaminated.
How to Drain Your Pool and Long Term Storage:
1. Adults shall drain and store the pool. Check local regulations for specific directions regarding disposal of swimming pool
water.
2. Remove all accessories, toys, garden hose, etc from the pool.
3. Open the drain valve cap (vary from models).
4. Carefully open the inflation valve caps and/or exhaust valve caps to deflate the air chambers, and slowly push the
sidewall inward and down to speed up the drainage of the pool. Slowly lift one side of the pool to drain out the remaining
standing water.
5. Re-insert all valve caps afterwards for storage.
6. Be sure pool and all parts are completely dry before folding, let it sit under the sun for an hour.
7. Fold and store the liner and accessories in a dry, clean indoor storage location. The original packing carton can be used
for storage.
Repair patch:
A repair patch has been included with the product to repair small leak and holes. Refer to the instructions on the back of the
repair patch.
SAVE THESE INSTRUCTIONS
Page 2
(234) INFLATABLE AND PLAY CENTER POOL 4.875" X 6.3" 05/20/2021
234