Kohler Windward K-1112-GLA Diagrama De Instalación página 2

No change in measurements if connected with
drain illustrated. (K-11677 or K-11677M)
Recommended faucet area
1-1/4"
(3.2 cm)
Tile Flange
Detail
42" (106.7 cm)
1-1/2" OD
Product Information
Applicable product:
Integral apron, left drain
Integral apron, right drain
Fixture*:
Bathing well
Basin area 43" (109.2 cm) x 24-5/8" (62.5 cm)
bottom
Basin area top 53-1/2" (135.9 cm) x 32-1/8" (81.6 cm)
Weight 120 lbs (55 kg)
To overflow
Water depth 15" (38.1 cm)
Capacity 57 gal (215.9 L)
* Approximate measurements for comparison only.
Blower motor: Heater
1 Hp 300 W
Required Electrical Service
Dedicated circuit required, protected with a Class A
Ground-Fault Circuit-Interrupter (GFCI):
Pump/control
Blower motor is supplied with a 24" (61 cm) grounding-type
plug-in cord.
1076048-1-A
Blower/Control Access
20" (50.8 cm) W x
15" (38.1 cm) H Min
1-1/4"
(3.2 cm)
21"
(53.3 cm)
K-1112-GLA not shown
K-1112-GRA shown
V Hz A
120 60 5
120 V, 5 A, 60 Hz
10-13/16"
(27.5 cm)
60" (152.4 cm)
2-7/8" (7.3 cm)
3" (7.6 cm)
Notes
Install this product according to the installation guide.
Floor support under this product must provide for a minimum of
36 lbs/square foot (174 kg/square meter) loading.
If installing a rim-mount faucet, make sure there is no interference
with the drain overflow and circulating system before drilling any
holes. Consult local and national codes for minimum air gap
requirements if installing a spout on the faucet deck.
This fixture conforms to ANSI Standard Z124.1.2. All dimensions
are nominal.
2
21"
(53.3 cm)
3-1/8"
(7.9 cm)
1-1/4"
(3.2 cm)
3-1/2"
(8.9 cm)
1" (2.5 cm) from
the Floor to the
Bottom of the Drain
Kohler Co.