Publicidad
Idiomas disponibles
Idiomas disponibles
CP 88105
INSTALL MOUNTING BRACKET
1. Mount the mounting bracket onto outlet
box by the 2 screws. Spring washers and
flat washers.
4. Connect the remote control's chips with
those of the ceiling fan and the wall
support.
BLADE ATTACHMENT
Note: Before installing the fan, you need to attach the blades onto the motor.
Insert the blade through the slot on the centre band. Align holes and fasten the blade to the motor with
provided screws. Repeat this procedure for remaining blades. Warning: Make sure all screws are tightened
securely.
Important: The bulbs for this fan must be E27 / 40W (X2).
REMOTE CONTROL
- Use the remote control transmitter to change the speed of the fan and to switch the light and fan on or
off.
- Replace the batteries by sliding the battery compartment cover on the remote control transmitter in
the direction of the arrow, fit one 6LF22 9V battery, and ensure the polarity of the batteries match
with the figures shown in the battery compartment. (Note: Batteries NOT included).Re-assemble the
battery compartment cover.
- Always ensure the battery compartment cover is closed properly.
- Don't expose the remote control to direct sunlight.
- Don't attempt to recharge expired batteries. There are special rechargeable batteries, which are clearly
marked with.
- Don't dispose of batteries in fire to avoid explosion.
2. Hang the ball joint and the fan onto the
bracket. Make sure the guied pin of
bracket is fitted into slot of ball joint.
5. Connect wires from supply and the
bracket to the wiring terminals as follow :
Brown wire « L »
Blue wire
« N »
Green/yellow stripes wire « earthing».
3. Insert the remote control receiver
between
the
bracket
and
downrod. And the sensor as shown.
6. Fix canopy onto the bracket by
tightening the screws.
the
11
Publicidad
