Publicidad
Idiomas disponibles
Idiomas disponibles
SYSTEM INCLUDES:
• Sunburst CMh 315W fixture – (1)
• Reflector hanging hooks – (2)
• 8' grounded power cord – (1)
• Lamp – (1)
DESCRIPTION
Thank you for your purchase of a Sunburst Ceramic Metal Halide All-In-One Lighting System. The
Sunburst CMh is an efficient electronic ballast and reflector in one compact package (includes CMh
lamp). It delivers more usable light energy for maximum plant performance and operates at cooler,
quieter levels than any other compact system on the market.
This Sunburst model accepts only the 315W ceramic metal halide lamp (type T12 38 mm PGZX18
base).
INSTALLATION
1. Carefully remove all of the components from the box and the protective cardboard to ensure that
your Hydrofarm Sunburst box includes all of the parts listed in the "SYSTEM INCLUDES" section.
2. Inspect the included components for any damage, missing parts, or other concerns. Contact your
local retailer in order to get a replacement or new part if required.
3. If there is a protective film on the reflector surfaces, be sure to remove it completely prior to
turning on the system.
4. Remove the lamp from its packaging and install it carefully into the socket. Take care to insert the
semi-circular pin on the lamp into the matching semi-circular hole on the socket. Making sure the
lamp is fully seated in the socket, turn the lamp a quarter turn. This will lock the lamp in place.
5. It is best to wear gloves when handling the lamp in order to avoid getting skin oils on the lamp's
envelope.
HANGING YOUR SUNBURST CMH FIXTURE
1. Make sure your unit is unplugged.
2. Use the included V-hangers by placing the two hooked ends of the hanger into the two holes in
the top of the reflector housing (hook ends facing inward).
3. Hang the fixture from a strong cord or chain from both ends (we recommend our Light Riser
System, item code LULIFT, for hanging the Sunburst CMh). If setting up in a room, make sure you
have hooks screwed solidly into the studs in the ceiling. If you cannot locate the studs, insert
expansion anchors (wall anchors) into the ceiling. The anchors, as well as the hooks used in them,
should be rated to hold at least 25 lbs each. If using a grow tent, you will need to simply hang the
unit from a top bar in the tent's framing.
4. Use a cable tie, twine, or similar method to secure the power cord to the hanging cord/chain so
that the power cord's weight doesn't tilt the fixture.
SPECIAL NOTES, INSTRUCTIONS AND OPTIONS
• The Sunburst CMh fixture is intended for 120-240V, 60 Hz operation.
• Avoid direct contact with water and liquids to prevent electric shock or internal damage to the
unit.
www.Hydrofarm.com
2
INSTRUCTIONS
Publicidad
