Sanitas SFS 40 Instrucciones De Uso página 7

of the device or mask. The water heating phase can also be shortened by closing the steam disc.
To avoid burns, never touch the steam outlet directly and ensure that the steam can come out of the
valve freely.
Now sit down in front of the device. Bend forward until your face is above the mask.
If the steam feels too hot, increase the distance in order to avoid burns.
caution:
During the treatment, you should always turn the switch back to position "1".
Do not keep your face too close to the mask as otherwise burns can occur because of the intensity of
the steam.
When you want to stop using the device or the water has evaporated, turn the switch back to position
"0". The device's indicator goes out.
Rinse your face with cold water after use. Then apply a face cream or mask. The opened pores let the
active ingredients penetrate deep into the skin.
Do not use the facial sauna for more than 20 minutes per day. Using it 2–3 times a week is recommen-
ded.
5.3 use of medicinal herbs, oils and other aromatic substances
The aroma attachment enables you to use medicinal herbs, oils and other aromatic substances as part
of an aromatherapy treatment. This is the best way for medicinal herbs, oils and other aromatic sub-
stances that mix with the steam to exert their effect. However, no solutions containing salt should be
used.
Only use medicinal herbs, oils and other aromatic substances that are intended and suitable for use with
a steam mask and are licensed for this by the producer of these substances.
use:
Open the lid of the aroma attachment. Put a few drops of the oil on a cotton wool ball. Put in the cotton
wool ball and then close the aroma attachment.
6. cleaning and care of the device
Unplug the device. Let it cool for about 10–15 minutes before taking the steam mask off the basic unit
by turning it anticlockwise. Empty the water container by holding it upside down.
Clean grease and chalk deposits after each use with a commercially available decalcification agent sui-
table for aluminium.
Use a soft and slightly moistened cloth to clean the surface of the device and the steam mask and then
wipe the surface dry.
• Do not use harsh agents (e.g. alcohol, acetone, benzine or abrasives) to clean the plastic parts.
• Unplug before cleaning.
• Do not use any sharp or pointed objects for cleaning.
• Do not immerse the device in water.
7. Disposal
Please dispose of the device in accordance with the directive 2002/96/EG – WEEE (Waste
Electrical and Electronic Equipment). If you have any queries, please refer to the local authorities
responsible for waste disposal.
Veuillez lire attentivement ce mode d'emploi et suivre les instructions qu'il contient, gar-
dez-le pour un usage ultérieur et mettez-le à la disposition des utilisateurs.
FRAnçAIS