Important - BIEMMEDUE LIBRA Manual De Instrucciones

FILTER FOR VACUUMING PARTICULATE (NOT STANDARD)
- For vacuuming particulate a special filter in sponge is supplied (only on request).
Thanks to its particular shape it is able to trap all of the most common particulates (flour, talc,
chalk).
To use it correctly put on the filter as shown in figure 15.
- Clean the filter under running water after each use.
STEAM FOR ECOLOGICAL CLEANING
- Refill the tank with clean water. (FIG.16)
Use tap water only. Do not use distilled or demineralised water.
A cap of scale remover also needs to be put in the tank. The scale remover is supplied with
the machine. only use the scale remover recommended by the manufacturer to prevent
damage to the machine or injury to the user.
Failure or incorrect use of the scale remover may cause the formation of lime sediments
with consequent hydraulic damage, thus jeopardising correct operation of the machine.
- Insert the plug in the appropriate socket (FIG.17)
- Insert the hose. (FIG.18)
- Turn the machine on in steam mode: Press the button to start boiler heating. (FIG.19)
- Select steam: (FIG.20)
Press the steam selection button on the handle to select the desired dispensing MIN-MED-
MAX(FIG.23)
1 press = MIN DISPENSING
2 presses = MED DISPENSING
3 presses = MAX DISPENSING
Use of the trigger (1) can be disabled by using the safety button on the handle. By pressing the
safety button on the left side of the handle (2) the trigger is disabled. By pressing the safety button
on the right side of the handle (3) the trigger is enabled. In addition, by pressing the button (3) it is
possible to enable or disable the steam and/or water dispensing function.
- Steam dispensing: press the lever on the handle to dispense steam, when it is released
steam dispensing will stop.
IMPORTANT - Discharge the condensation that accumulates with the first passage of
steam in the hose.
or after it has not been used for some time.
- Insufficient water in the tank
When the red indication led flashes, and an acoustic signal goes off at the same time it
means that the water in the tank is about to run out, by filling the tank again it is possible to
continue to use the steam. (FIG.24)
sponge filter
Carry out this operation every time you start to use the generator