Connecting To External Av Signal Source (Hdmi); Connecting A Usb Devices - Odys MONO X26 Manual Del Usuario

4.4

Connecting to External AV Signal Source (HDMI)

Follow the figure below to connect an HDMI signal source to the HDMI jack on the rear panel of the
unit.
After connection, turn on the power of the unit and the external AV signal source and use the
SOURCE and the direction buttons to select HDMI mode, and then press the OK button to confirm.
HDMI provides both audio and video signals and typically provides superior image quality
to component, S-Video or composite.
4.5

Connecting a USB Devices

This unit is designed with a USB port, can be connected to the USB device, see the figure below:
Please only connect compatible devices with playable content.
The device supports USB devices with FAT or FAT32 disk system up to 500GB.
Please only use harddisks with separate power supply.
If possible, please connect USB devices directly to the Devices USB interface.
If this is not possible, use only USB extension cables not exceeding 25 cm.
ODYS MONO X
13