Heath Zenith DualBrite Manual Del Usuario página 3

4. Rotate the mounting plate so the wire path
is on the upper right. Note: The wire path
on the mounting plate must be located
as shown below to allow the wires on the
back of the fixture to pass through.
5. Reinstall the fixture mounting screws and
attach the mounting plate to the junction
box as shown.
Wire Path
Ground Screw
Fixture Screws
As Shipped
WIRING
Note: All wiring should be run in accordance
with the National Electrical Code through
conduit or another acceptable means.
Contact a qualified electrician if there is
any question as to the suitability of the
system.
CAUTION: DO NOT connect the RED
wire unless you want to control other
lights from the motion sensor.
Black
Green
or Bare
White
One Motion Light
598-1207-01
All manuals and user guides at all-guides.com
Wire Path
Flipped and
Rotated
Light
Fixture
3
White
Black
Green
or Bare
Two Motion Lights
❒ Twist the junction box wires and the
fixture wires together as shown below.
Secure with wire connectors. If you have
a metal junction box, you may not need
the green "pigtail". If you are unsure about
the grounding method, consult your local
building code.
Connect the fixture wires to the wires in the
junction box. Twist the wires together and
secure with wire connectors.
Recommended Grounding Method
Use a green ground "pigtail" (not provided) and
twist one end together with the bare fixture wire
and the box ground wire. Secure with a wire
connector. Secure the other end of the "pigtail"
with the GND screw on the mounting plate.
Black to black
Light Light
Fixture Fixture
White to white