Mopar 82210720 Instrucciones De Montaje página 3

STEP 8
Position the nut insert into clips. Slide clips over the
abrasive resistant tape on hood lip, as shown. Ensure that
the clips are positioned over the abrasive resistant tape
and do not come in contact with hood paint work. Failure
to do this may result in permanent paint damage. Secure
Hood Protector to clips with small screws and washers
provided.
TO REMOVE: Reverse the above procedure.
See FIGURE 8.
STEP 9
Note the three rubber bumpon's on the Hood Protector.
Using a pencil or non-permanent marker, carefully mark the
corresponding bumpon locations onto the hoods surface.
See FIGURE 9.
STEP 10
Using the alcohol wipe provided, clean the noted and
marked areas beneath the rubber bumpon's. Wipe away
any residue with a clean dry cloth. Adhere the small
abrasive resistant tape strips provided, to these locations.
See FIGURE 10.
FAILURE TO ADHERE THE TAPE STRIPS MAY RESULT
IN PERMANENT PAINT DAMAGE TO YOUR VEHICLE'S
PAINTWORK.
NUT
INSERT
8
9
10
K6860440
HOOD
PROTECTOR
SMALL
SCREW
WASHER
NUT
INSERT
BUMPON
SMALL
ABRASIVE
RESISTANT
TAPE
SUP 324
3/9
82210720