General Information; Preparing For Installation - Stiebel Eltron KGS Instrucciones

InStallatIon
collector handle set
enGlISh

1. General information

these instructions are intended for contractors.
Note
Read these instructions carefully before using the ap-
pliance and retain them for future reference.
Pass on the instructions to a new user if required.
1.1 Relevant appliances
- 231906 KGS
1.2 Relevant documents
Hinweis
Please observe the flat-plate solar collectors operating
and installation instructions.
2. Safety
Intended use
the collector grip set consists of four grips. For transport and
during installation, the grips can be attached to the collector
quickly and easily.
any other use beyond that described shall be deemed inap-
propriate. observation of these instructions and of instructions
for any accessories used is also part of the correct use of this
appliance.
3. Transport
Material losses
!
If the collectors are moved using a crane, the collector
grips must not be subjected to a direct load. We accept
no responsibility for damage resulting from improper
use of the grips.
KGS

4. Preparing for installation

4.1 Preparing
f using the star-shaped knobs, screw both fixing screws in f
or out until they are seated flush in the rivet nuts.
4.2 Positioning
f Position the grip on the collector so that it engages f
around the foot of the collector at the bottom.
f Slide the grip upwards. f
It must be seated in the groove of the collector head at the top
and in the groove of the collector foot at the bottom.
4.3 Tightening
f When the grip is positioned correctly, hand-tighten the
f
fixing screws.
f Screw the remaining grips on in the same manner if f
required.
| 3