Shure AXT610 Manual De Instrucciones

AXT610 -- Punto de acceso ShowLink
Punto de acceso del AXT610 ShowLink
El punto de acceso del AXT610 ShowLink™ hace posible el control remoto en tiempo real de los transmisores
Axient™. El punto de acceso permite controlar los parámetros del transmisor desde el receptor o desde el softwa­
®
re Wireless Workbench 6 por medio de comunicación de red inalámbrica de 2,4 GHz. Todos los cambios de pa­
rámetros ocurren sin que haya interrupción para el participante.
Los varios puntos de acceso pueden extender el intervalo de funcionamiento o aumentar el número de transmiso­
res que funcionan en la red ShowLink.
Features
• Real-time wireless remote control of up to 16 transmitters per ShowLink access point
• Automated channel selection - Independently scans 2.4 GHz frequency range and determines best channel for
use
• Receives power via Power over Ethernet (PoE) network connection or from an external power supply
• Easy transmitter authentication - Recognizes linked transmitters upon IR sync
• Provides coverage area approximately the same as the transmitter's UHF range (depending on the RF squelch
setting of the receiver)
• Automatic hand-offs between multiple access points extend coverage range
• Automatic frequency agility - Moves a ShowLink network to the best available 2.4 GHz channel in the event of
signal degradation
• Versatile mounting options - Fits readily available microphone stand adapters and features built-in threading for
permanent installation
• Wireless Workbench 6 system supports networked control of all device functions and provides a ShowLink plot
for viewing 2.4 GHz signal levels
ShowLink Access Point Overview
① ShowLink 2.4 GHz detachable antenna
For 2.4 GHz signals
② ShowLink Data Status LED (blue)
• ON Steady: Linked, no data transmission
1/12