Technical Data - Desoutter Nano 6 I/O Manual De Instrucciones

6159922290_04
Original instructions.
© COPYRIGHT 2017, ETS GEORGES RENAULT
44818 ST HERBLAIN, FR
All rights reserved. Any unauthorized use
or copying of the contents or part thereof
is prohibited. This applies in particular to
trademarks, model denominations, part numbers
and drawings. Use only authorized parts. Any
damage or malfunction caused by the use of
unauthorised parts is not covered by Warranty or
Product Liability.
STATEMENT OF USE
This product is an accessory designed for
transferring information be tween the PC control
panel and external devices.
No other use is permitted.
For professional use only.

TECHNICAL DATA

General
Operating temperature 0°C to 40°C
Storage temperature
Nano 6 I/O - Rear panel
6 isolated 5V inputs
6 isolated 24V outputs
24VDC/0.4A power inlet: screw clamp
terminal
1 GPIO Comms (HD15)
1 DIO Comms (HD15)
Micro 16 I/O M12 connector
● See page 4.
24VDC/1.5A power inlet: 1x male M12
- Inputs/Outputs: 16x female M12
- Ethernet: 2x RJ45
Nano 6 I/O
● See page 5.
● Contact your local Desoutter
representative for more information.
-20°C to 75°C
INSTALLATION
The manufacturer cannot be held
liable for damage caused by using the
product for purposes contrary to the
designated use or by ignoring safety
instructions and warnings.
● Refer to the diagrams page 6.
How to change the IP address of the Micro
● Connect the Micro to your computer using an
Ethernet Cable:
● From the Windows taskbar, click "Network and
Sharing Center" and change your computer's
Ethernet port to an IPv4 address between
192.168.10.1 and 192.168.10.254 (except
192.168.10.58).
● Click "Windows / Start / CMD" and ping
the IP Address of your Micro (by default
192.168.10.58). Hit the Return key and check
that replies are successful between your
computer and the Micro.
8 / 16
English
09/2017