Select Display Mode; Battery Replacement; Troubleshooting - TFA eco solar 30.2026 Instrucciones Para El Manejo

TFA_No. 30.2026_Anleitung_02_21
AVENUE – Garden thermometer with solar lighting
• PM appears on the display after noon.
• Close the battery compartment again.
5.3 Daylight Saving Time / Standard Time switch
• When the time appears on the display hold +/-1 Hr button outside the battery compartment
for 3 seconds and summertime changes in to wintertime and vice versa (+/-1 hour).
• Please pay attention to the correct setting at the startup procedure.

5.4 Select display mode

• Switch position A: Current temperature (display: >)
• Switch position B: Current temperature and time alternately (display: >>)
• Switch position C: Current temperature, highest/lowest temperature and time alternately
(display: >>>)
5.5 Maximum and minimum temperatures
• There is an automatic update of maximum temperature at 8:00 and minimum temperature at
20:00. Please set the actual time to activate this function.
• Auto Reset flashes on the LCD.
5.6 Temperature probe
• The silver pin is the temperature probe. Please take care of it and do not break it. The tem-
perature probe has no adjusting function. It only measures the temperature.
5.7 Backlight and fixing
• The supplied battery will be recharged in an environmentally friendly manner by the solar
panel.
• Please consider when choosing a location that the solar panel needs at least 8-10 hours of
light per day to guarantee a long-term sufficient power supply. Attention: Direct sunshine
falsifies the measurement.
• The thermometer is provided with a light sensor to turn on the light automatically at dark
between 5 and 9 o'clock and 18 and 23 o'clock. Avoid the closeness of artificial light (like:
street lighting).
• With the ECO slide it is possible to turn the time controlled illumination on (left) or off (right)
14
05.02.2021 11:36 Uhr Seite 8
AVENUE – Garden thermometer with solar lighting
• If the ECO mode is not active the illumination will turn on automatically as soon as the light
sensor indicates darkness.
• When the battery symbol appears on the display, the voltage of the rechargeable battery is
low and the back light function can be temporarily disabled, until the power supply by the
solar panel is sufficient again.
• Press the plate firmly into the ground.
• Mount the rod and put it into the ground passing through the hole in the middle of the plate.
Fix the thermometer on the rod and turn the solar panel (rotatable 180°) to the direction
where it receives the highest light supply.
6. Care and maintenance
• For best function keep the solar panel always clean. Clean it with a soft cloth and maybe a lit-
tle glass- or display cleaner. Do not use solvents or scouring agents.
• Remove the battery if you do not use the product for a long period of time.

6.1 Battery replacement

• Please change the 1.5 V AA battery when the display becomes weak.
• Use alkaline batteries only. Observe correct polarity.

7. Troubleshooting

Problem Solutions
➜ Ensure correct polarity when inserting the battery
No display
➜ Change the battery
Incorrect indication
➜ Make sure that no objects cover the solar panel
No illumination
(see point 5.7)
8. Waste disposal
This product has been manufactured using high-grade materials and components which can be
recycled and reused.
15