Publicidad
CONTROLS & FUNCTIONS
1. POWER LED
Indicates if the power is on or off (lights up
when on).
2. GAIN CONTROL
Use this dial to adjust the input signal level (0dB
to +10dB).
3. TREBLE/ BASS CONTROL
Controls the High (Treble) or Low (Bass)
frequencies for each channel (-15dB to +15dB).
4. CUE VOLUME
Adjusts the headphone output volume (0dB to
+10dB).
5. CUE CROSSFADER
Fades between channels 1 and 2 for the
headphone output. When the crossfader is in
the centre position both channels are played
equally.
6. CHANNEL FADER
Adjusts the volume level of each channel.
7. CROSSFADER
Fades between channels 1 and 2 for the master
output (to be used as desired once gain levels
have been set). When the crossfader is in the
centre position both channels are played
equally.
8. USB TO CH2 SWITCH
When ON (pressed in), the USB input is active
on channel 2. When OFF (pressed out), the USB
input deactivated, and the Line/Phono Inputs
are active on channel 2.
9. LEVEL METER LED
Level meter displaying the output signal level.
10. MIC/AUX VOLUME
Controls the volume level of the MIC and AUX
inputs.
11. MIC IN
Unbalanced 6.3mm (1/4") TS Jack input
connection for microphones.
12. AUX IN
3.5mm TRS Jack input connection for playback
devices.
13. PHONES OUT 6.3mm (1/4") TRS Headphones
output.
14. POWER SWITCH Turns the mixer on or off when
the power supply is connected.
15. AC IN Connection for the supplied AC power
supply.
16. USB CONNECTION 2.0
USB B connection for recording or playback to
or from a laptop or computer.
17. MASTER OUTPUT CONNECTION
Master output connections (RCA Phono).
18. CHANNEL 1 LINE CONNECTION
Line connection for channel 1 (i.e. CD Players)
(RCA Phono Connector).
19. CHANNEL 1 PHONO CONNECTION RCA
Phono connection for channel 1 (i.e. turntables)
(RCA Phono Connector).
20. CHANNEL 2 LINE CONNECTION
Line connection for channel 2 (i.e. CD Players)
(RCA Phono Connector).
21. CHANNEL 2 PHONO CONNECTION RCA
Phono connection for channel 2 (i.e. turntables)
(RCA Phono Connector).
22. LINE/PHONO SWITCH
Select Line to use the Line input or Phono to
use the phono devices.
23. GND TERMINAL
Connection for the ground/earth wire from
phono devices (to provide earth grounding for
turntables with earth grounding requirements).
7
Publicidad
