Using The Avertv Dvi Box7; The Remote Control - Avermedia AVerTV DVI Box7 Manual De Usuario

3.1 Using the AVerTV DVI Box7

Different countries have different TV systems, for example, PAL-BG, PAL-DK, NTSC-J, NTSC-M...etc. AVerTV Box
functions only with the TV system of the country it is manufactured for and originally distributed in.
Make sure that you select the correct country signal from the menu. To change the area setting, refer to "SET AREA"
(page 8).
To ensure that you can select and watch all active channels, refer to section "CH SCAN" (page 7) on how to
automatically scan and memorize all active TV channels in your area.
To access various TV controls, open up the menu displays or press on the remote control buttons.

3.2 The Remote Control

The diagram below shows the remote control unit layout.
13
14
15
16
17
18
9. PIP
10. MTS/ STEREO
11. PICTURE
12. PC BGM/ Res.
13. SOURCE
14. MUTE
15. PREVIEW
16. CH▲/▼
17. SLEEP
18. AV/PC
1. POWER
2. NUMBER BUTTONS
1
3. CHANNEL RETURN
2
4. MENU
5. VOL ◄/►
3
4
5
6
7
8
6. OK
9
10
7.
11
12
8. PIP Pos.
Switch between PIP*, PIP See-thru** and Full Screen mode
* To watch TV/Video in a small screen on an always on top of the PC
display.
** Make the small video screen semi-transparent allowing the image
behind the small screen show through.
If the channel offers the multi-language feature, press this button to toggle
between languages.
To adjust brightness, contrast, color, tint or sharpness
Note: The Tint control will not work with a PAL/SECAM source.
- Switch the audio source when in PC display mode
- Switch display resolution setting to 1024x768 when in TV/Video mode
Switch between TV or external video sources
To turn off /on the sound
Display 13 consecutive TV channels on-screen.
-Go to the next or previous TV channel line up
-Use these buttons to make the selection in the menu or picture setting
-In adjusting the PIP window position, use these buttons to move the menu
display up and down of the screen
To automatically turn off the unit after 30, 60, 90, 120 or 150 minutes.
To toggle between TV/ Video or PC display
ENG-5
User's Manual
Turn the unit on/off
To select a TV channel
Go to the previously selected channel
To call up the menu display
-To increase and decrease volume
level
-Use these button to adjust the menu
or picture setting
-In adjusting the PIP window position,
use these buttons to move the menu
display to the left and right of the
screen
In the menu, press this button to
confirm the selection.
To temporarily freeze the image on
the screen. Press the button again to
unfreeze the image.
To move the small TV/Video screen
using the CH▲, CH ▼, Vol◄, and
Vol► buttons in PIP mode. Press this
button again to exit the adjusting
mode.