MOTOR
PROTECTION
SYSTEM
Thermal Protector - Suction Motor
This vacuum cleaner has a thermal
protector which automatically
trips to
protect the vacuum cleaner suction motor.
If a clog prevents the normal flow of air
to the motor, the thermal protector turns
the motor off automatically.
This allows
the motor to cool in order to prevent
possible damage to the vacuum cleaner.
Thermal Protector - Agitator Motors
This vacuum cleaner has thermal
protectors which automatically
trip to
protect the agitator
motors. The thermal
protectors turn the motors off
automatically.
This allows the motors to
cool in order to prevent possible damage
to the vacuum cleaner.
To reset thermat protectors: Turn the
vacuum cleaner off and unplug the power
cord from the outlet to allow the vacuum
cleaner to cool and the thermal
_rotectors to reset.
CAUTION
Always return the vacuum cleaner to the
upright position before using the hose
and attachments. Failure to do so may
result in overheating
of the agitator
motors and can cause the thermal
protectors to tr_p.
Check for and remove clogs, and replace
bag if necessary. See REMOVING CLOGS
Section (Page 19-20). Also check and
replace any dogged filters. Wait
approximately
50 minutes before
restarting vacuum cleaner.
BY-PASS VALVE
This vacuum cleaner has a By-Pass Valve
which prevents motor overheating and
damage. The valve opens to provide
cooling air when a dog prevents normal
air flow to the vacuum cleaner suction
motor. You will notice a change of sound
as air rushes through the valve opening.
-- By-pass
Valve
To correct problem, instalt a new dust
bag. If using attachments, adjust suction
control to allow for greater air flow.
NOTE: The By-Pass Valve may open when
using attachments
or when cleaning new
carpet due to reduced airflow caused by
the attachments themselves or by new
carpet lint filling the dust bag quickly.
NOTE: Do not block By-Pass Valve.
-13-