Sears Kenmore Elite 116.31150 Manual De Uso página 21

Ocultar thumbs Ver también para Kenmore Elite 116.31150:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Review this table to find do-it-yourself solutions for minor performance problems. Any service
needed, other than maintenance described in this Use & Care Guide, should be performed by
a Sears or other qualified service agent.
WARNING
Disconnect electrical supply before performing
maintenance
to the vacuum
cleaner. Fail-
ure to do so could result in electrical shock or personal injury.
l
PROBLEM
Vacuum cleaner
won't run.
Poorjob of dirt
pick-up.
Vacuum
cleaner
picks up moveable
rugs or pushes too
hard.
Agitator
does not
turn.
Airflow restricted
with attachment use;
sound changes.
I
I. UnpJugged at wail outlet.
I.
2. Tripped circuit breaker
2.
or blown fuse.
3. Thermal protector tripped.
3.
4. Defective wall outlet.
4.
1. Full or clogged
dust bag.
1.
2. Wrong
pile height setting.
2.
3. Worn agitator.
3.
4. Clogged
nozzle or
4.
bag holder.
5. Clogged
hose.
5.
6. Hole in hose.
6.
7. Hose not inserted fully.
7.
8. Motor protection
system
8.
activated.
9. Dirty filters.
9.
10. Clean-out
port not closed.
10.
1. Wrong pile height setting.
1.
1. Handle in full upright position.
1.
2. Agitator overload protector
2.
tripped
3. Thermal protector tripped.
3.
4. Switch in FLOOR position.
4.
1. Attachment use restricts
1.
air flow.
2. New carpet fuzz clogged
2.
air path.
POSSIBLESOLUTION
]
Plug in firmly, select the
desired setting on the touch
control.
Reset circuit breaker or
replace fuse.
Allow vacuum cleaner to cool
50 minutes. (Page 13)
Check with a good appliance
or lamp. Have outlet properly
serviced.
Change bag. (Page ]6)
Adjust setting. (Page ]0)
Replace agitator.
Check REMOVING
CLOGS.
Pages 09-20)
Check for clogs. (Pages ]9-20)
Replace hose.
Insert hose fully.
Check for clogs. (Pages 19-20)
Clean or change motor
safety filter and exhaust
filter. (Page ]7)
Close clean-out
port. (Page 20)
Adjust
setting.
(Page 10)
Move handle from upright
position.
Reset agitator overload
protector. (Page 14)
Allow vacuum cleaner to cool
50 minutes. (Page 13)
Move switch to CARPET position.
Check attachments for
fuzz, lint, pet hair or other
debris.
Check REMOVING CLOGS
and clean hose. (Pages 19-20)
=21 =

Publicidad

Tabla de contenido
loading

Tabla de contenido