Lab.gruppen IPD Serie Guia De Inicio Rapido página 7

Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

DSP configuration
Default configuration
IPD Series amplifiers are shipped with default DSP settings that allow
immediate use in many common applications with no need for further
DSP configuration. The default mode is suited for use with the stereo
program into full range loudspeakers. The main signal routing and
parameter settings are as follows:
Input mixer:
Analog 1 and AES1 are routed to Ch. 1
Analog 2 and AES 2 are routed to Ch. 2
AES3 to analog failover is OFF
Mode: Stereo
Input levels: 0 dB
Input EQ: Flat
Output levels: 0 dB
Fig 2
Analog 1
Analog 2
Input
Mixer
AES 1
AES 2
Fig 3
Presets
Meters
Load
Mixer
Store
I/O Meters
Output Mute: Muted
Output EQ: Flat
Delay: Off
Crossover: Off
Input 1
Input 1
Input 1
Levels
EQ
delay
Input 2
Input 2
Input 2
Levels
EQ
delay
Device Config
Device
Mode
Name
LCD
Lock
Brightness
Signal flow block diagram
The block diagram below shows the signal flow from inputs to outputs.
*see fig 2
Front panel configuration
Input mixing and routing, as well as all DSP parameters, may be
configured using the Menu and Back buttons and the Adjust/Set rotary
encoder. The following menu tree is keyed to points in the signal flow
block in fig 2.
*see fig 3
Output 1
Output 1
X-Over
Levels
Output 2
Output 2
X-Over
Levels
Input 1 & 2
Imput
Gain
Gain
Mixer
Delay
Link
Link
PEQ 1-10
Enable
Phase
Type
Freq
Norm/
Invert
Gain
Q / BW
Limiter
Threshold
7
Clip Limiter
Output 1
SCVPL
EQ
Delay
Rail Sense Limiter
Output 2
SCVPL
EQ
Delay
Clip Limiter
Output 1 & 2
Device Info
Serial
Delay
Number
X-Over
Temperature
HPF
Reading
LPF
Mac
Address
PEQ 1-10
Enable
Type
Freq
Gain
Q / BW
IDEEA
Amplifier
PSU
IDEEA
Amplifier
Software
Version
H/W Version
IP Address

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Ipd 2400Ipd 1200

Tabla de contenido