Sound; Sound Effect; Balance; Smart Volume - TCL 48P1CFS Guia Del Usuario

Sound

Sound 120Hz 50
Sound 500Hz 0
Sound 1.5KHz 0
Sound 5KHz
0
Sound 10KHz
0
This menu allows you to adjust each option to obtain the
best sound settings to optimize audio output.
Press MENU to display the main menu and select
Sound, then press OK to confirm. The Sound options
are as follows:

Sound Effect

Press OK to enter. Press ▲/▼ to select Sound Effect
among Standard, Movie, News, Music and User.
Note: When Sound Effect is set to User, five more
Sound options (Sound 120 Hz, Sound 500 Hz, Sound
1.5 KHz, Sound 5 KHz, and Sound 10 KHz) will be
displayed, which enable you to adjust the frequency
levels desired.

Balance

Press ◄/► to balance the sound between the left and
right speakers.

Smart Volume

To keep the same sound level for all channels, set
Smart Volume to On or Off.

SPDIF Mode

This option is used to control the type of audio stream
sent to the Digital Audio Output (SPDIF) socket. Press
▲/▼ to select Auto or PCM.

SPDIF Delay

This option is used to synchronize the sound with the
picture. If the sound is slower/quicker than the action
of the picture, you can press ◄/► to turn down/up the
numerical value.

Sound Type

Press ▲/▼ to select Stereo, Mono, or SAP.
Note: The options available may vary depending on the
channel's signal.
System Settings Menu

Channel

When you first used your TV you will have to set up your
TV for DTV/ATV channels using the Initial Setup menu.
If you did not do this or if your setup has changed, you
can do this from this menu.
Press MENU to display the main menu and select
Channel, then press OK to confirm. The Channel
options are as follows:

Channel Scan

This allows you to scan for all available analog and
digital channels.
The options are as follows:
- Auto Search:
1. Select Channel > Channel Scan > Auto Search,
and then press OK to enter.
2. Press OK to start the channel scan. The search
process may take a few minutes. During the
process, you can press MENU or EXIT to abort
halfway.
3. Once the scan ends, the TV automatically goes to
the first channel searched, and all channels are
arranged in a preset order. You can press CH LIST
to display the channel list.
- DTV Manual Search
This allows you to scan for all available digital channels.
Note: This function is only for digital channels.
1. Select Channel > Channel Scan > DTV Manual
Search, and then press OK to enter.
2. Press OK and then press ◄/► to select a one-
digit or two-digit channel number, and press ▲/▼
to select Finish and then press OK. Press OK to
start scanning for channel(s) of the selected channel
number.
3. Press BACK to return or EXIT to close the menu.
- ATV Manual Search
This allows you to scan for all available analog
channels. Operations are similar to that of DTV Manual
Search.
18