Usb Data Cable To Use; T-Flash Card To Install/ Remove; Basic Instructions; Keyboard Introduction - Huskee VULKANO Manual De Instrucciones

Note: If the screen says "no service" means that you hare out of the normal
network coverage (service area), but you can still send an emergency call as the
signal strength.

2.5 USB data cable to use

The way of using USB data cable: one end of the USB data cable is inserted into
the PC (personal computer) on the USB port, then connect the other end to the
bottom of the phone, "Charge / Data Interface" on.
The phone supports USB, USB data cable you can connect your phone to your
computer, mobile phone and the computer to copy, move files, etc, T can also
browse the photos stored on the card, audio, video and other documents.
Note: This phone only supports the power-state data transmission.

2.6 T-flash card to install/ remove

T-flash card, which is a multimedia memory card to increase memory, is
built into the fuselage of the phone. This relatively small card should be installed
or removed carefully to avoid damage. non-professional personnel had better do
not open the fuselage T-flash card extraction.
Note: This phone does not support T-flash card hot swap.

3.1 Keyboard introduction

3.1.1 Basic keys

ON / OFF button:
Ø

3. Basic Instructions