Mounting The Seat On The Machine; Adjusting The Machine At The Operating Location - Rohde HMT 600 Manual De Instrucciones Original

7.3.3.

Mounting the seat on the machine

WARNING
Never unscrew the machine feet further than the end of the scale ("STOP").
7.4.

Adjusting the machine at the operating location

WARNING
Never unscrew the machine feet further than the end of the scale ("STOP").
The machine should be aligned at the operating location with a spirit level or a two-axis spirit level (at right angles).
 The plastic feet can be screwed in or out to achieve this.
 For alignment, the spirit level should only be placed on the wheel head.
 When aligning, the use of the optional seat must be taken into account. The machine foot at the seat then has
to be unscrewed less from the foot tube than the other two.
The seat is inserted under the foot of the
pottery wheel. The foot below the pottery
wheel must be adjusted in height so that it is
not screwed out as far as the other two feet.
42 / 207 - EN -