Adjusting The Angle On The Foot Pedal; Installation; Installing The Wiring On The Machine; Installing The Power Cable On The Machine - Rohde HMT 600 Manual De Instrucciones Original

7.5.

Adjusting the angle on the foot pedal

The pedal angle of the foot pedal is set to the "steep" setting as standard on delivery. The pedal can be adjusted to a
"flat" setting.
Description
Flat setting
Lug in upper
Mounting angle attached to
detent
the outside of pedal body
Pedal underside
Mounting angle with
screw
(Tool: Phillips
screwdriver)
8.

Installation

8.1.

Installing the wiring on the machine

8.1.1.

Installing the power cable on the machine

DANGER
Danger high voltage!
Before working on the machine, pull the power plug out of the socket.
Lug in lower detent
Changing settings:
1) Loosen the mounting angle on the underside of the pedal with a Phillips
screwdriver.
2) Bring the pedal body into the required position.
3) Pay attention to the position of the lug on the short side of the pedal.
4) Reattach the mounting angle on the underside of the pedal with a Phillips
screwdriver (torque = 4 Nm).
5) Pay attention to the position of the mounting angle on the pedal body.
43 / 207 - EN -
Steep setting
Mounting angle attached to
the bottom of pedal body
Pedal body is
supported in a high
position