Product Specifications; Care And Maintenance - Homewerks Worldwide 3190-41-CH-B-Z Manual De Instrucciones

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

PRODUCT SPECIFICATIONS

SPECIFICATIONS
Max. Flow Rate: 2.2 GPM (8.3 LPM) at 60 PSI
ASME A112.18.1/CSA B125 certified
Meets ANSI/NSF 61-9
Ceramic cartridge
ASSEMBLY INSTRUCTIONS
1. Turn off water at the supply
valve under the sink or at the
main water supply, disconnect
the supply line, and remove old
faucet.
Clean and dry surface area
where new faucet will be
mounted.
2. Using thread sealant tape
(wrapped clockwise), or joint
compound, cover all exposed
male thread areas.
Insert faucet spout into faucet
body making sure the O-rings
snap into place. Hand tighten
spout nut over faucet body
threads
.
3. Hand tighten screw flanges
onto tailpieces, and with flange
attached to tailpieces, wrench
tighten tailpieces onto projecting
1/2" pipe nipples (stub-outs).
Do not over tighten. Adjust tail-
pieces so that they are equal in
measurement from wall surface
to the end of tailpiece thread.
The ends of the tailpieces can
accommodate a range of width
from 7-9".
OPERATION INSTRUCTIONS
Turn on water at handles and balance flow to achieve
comfortable temperature.
Do not hang heavy items like pails or buckets from the
faucet spout.

CARE AND MAINTENANCE

Clean periodically with a soft cloth. Avoid abrasive cleaners,
steel wool, and harsh chemicals as these will dull the finish
and void your warranty.
1
2
3
SPECIFICATIONS
Manufactured to include no more than 0.25% weighted
average lead content on wetted surfaces
Total weight of item: 2.84 lbs.
4. Insert washers into union nuts.
Wrench tighten union nuts
to faucet body (do not over
tighten).
5. Install soap dish (optional)
Hand tighten the soap dish rod
into the top of the nut at the
back of the faucet. Place the
soap dish on the threaded end
of the rod with the edge of the
soap dish parallel
to the wall. To adjust, rotate
soap dish clockwise.
Turn on water supply or shut-
off valve and check for leaks.
6. Remove aerator from spout.
Turn on faucet and run at least
30 seconds to flush water line.
Turn off faucet and replace
aerator.
Swivel spout to allow access to sink basin.
2
4
5
6
www.homewerksww.com

Publicidad

Tabla de contenido
loading

Tabla de contenido